Search results
Results From The WOW.Com Content Network
The modern toilet utilises a cistern to reserve and hold the correct amount of water required to flush the toilet bowl. In earlier toilets, the cistern was located high above the toilet bowl and connected to it by a long pipe. It was necessary to pull a hanging chain connected to a release valve located inside the cistern in order to flush the ...
A flush toilet (also known as a flushing toilet, water closet (WC); see also toilet names) is a toilet that disposes of human waste (i.e., urine and feces) by collecting it in a bowl and then using the force of water to channel it ("flush" it) through a drainpipe to another location for treatment, either nearby or at a communal facility.
Often old toilets still have high-level cisterns in the service ducts. On the outside, the toilet is flushed by a handle (just like an ordinary low-level cistern toilet) although behind the wall this handle activates a chain. Sometimes a long flushing trough is used to allow closets to be flushed repeatedly without waiting for the cistern to ...
It is designed to allow a shorter interval between flushes than individual cisterns. Flushing troughs were commonly used in places such as schools, colleges, public toilets, factories and public buildings where repeated use of the flushing cistern was required in a short period of time. Such troughs were used by local councils in the UK into ...
The lack of siphoning also means that the toilet requires less water to operate. [6] Due to this, the waterline is considerably lower than that in siphon-flush toilets. The toilet has two buttons on the cistern rather than the single-flush one; one button delivers a lesser amount of water (eg. 3 litres) and the other a greater amount (eg. 6 ...
A typical flush toilet is a ceramic bowl (pan) connected on the "up" side to a cistern (tank) that enables rapid filling with water, and on the "down" side to a drain pipe that removes the effluent. When a toilet is flushed, the sewage should flow into a septic tank or into a system connected to a sewage treatment plant .
In many modern boats, the heads look similar to seated flush toilets but use a system of valves and pumps that brings sea water into the toilet and pumps the waste out through the hull (in place of the more normal cistern and plumbing trap) to a drain. In small boats the pump is often hand operated.
A perforated disc (4) covered by a flexible plate or flap (5) is joined by the siphon rod (6) to the flush lever. Pressing the lever raises the plate, forces water over the top of the siphon into the vertical pipe, and starts the siphonic discharge. Water flows past the flap until the cistern is empty, air enters the siphon and the flush stops.