Search results
Results From The WOW.Com Content Network
The intersection of a UTM zone and a latitude band is (normally) a 6° × 8° polygon called a grid zone, whose designation in MGRS is formed by the zone number (one or two digits – the number for zones 1 to 9 is just a single digit, according to the example in DMA TM 8358.1, Section 3-2, [1] Figure 7), followed by the latitude band letter ...
For example, in the Military Grid Reference System, the above coordinate is in grid 11U (representing UTM Zone 11 5xxxxxx mN), and grid cell NS within that (representing the second digit 5xxxxxmE x6xxxxxm N), and as many remaining digits as are needed are reported, yielding an MGRS grid reference of 11U NS 949 361 (or 11U NS 9493 3617 or 11U NS ...
Under the Chairman of the Joint Chiefs of Staff Instruction CJCSI 3900.01C dated 30 June 2007, GARS was adopted for use by the US DoD as "the “area-centric” counterpart to the “point-centric” MGRS". It uses the WGS 1984 Datum and is based on lines of longitude (LONG) and latitude (LAT). It is intended to provide an integrated common ...
The procedure is repeated for all bits in the code. Finally, the latitude value is the center of the resulting interval. Longitudes are processed in an equivalent way, keeping in mind that the initial interval is −180 to +180. For example, in the latitude code 101111001001, the first bit is 1, so we know our latitude is somewhere between 0 ...
Latitude bands are not a part of UTM, [7] but rather a part of the military grid reference system (MGRS). [8] They are however sometimes included in UTM notation. Including latitude bands in UTM notation can lead to ambiguous coordinates—as the letter "S" either refers to the southern hemisphere or a latitude band in the northern hemisphere ...
For example, on a GEOREF chart, Naval Air Station Patuxent River (38°17′10″N 76°24′42″W) / (38.286108, -76.4291704) is located (to the nearest minute) at position GJPJ3417. To locate the position from the coordinates, proceed as follows: Right from 180° longitude to longitude zone G; Up from the South Pole to latitude zone J
WKT can describe coordinate reference systems. For example, the WKT below describes a two-dimensional geographic coordinate reference system with a latitude axis first, then a longitude axis. The coordinate system is related to Earth by the WGS84 geodetic datum:
In geodesy, geographic coordinate conversion is defined as translation among different coordinate formats or map projections all referenced to the same geodetic datum. [1] A geographic coordinate transformation is a translation among different geodetic datums. Both geographic coordinate conversion and transformation will be considered in this ...