Search results
Results From The WOW.Com Content Network
A gas spring consists of a sealed cylinder filled with a charge of high-pressure [5] gas, a piston rod attached to a piston with a sliding seal, and some oil. [1] The piston (or the cylinder wall) contains a number of channels that allow the gas to transfer between the lower chamber (between the piston and the closed end of the cylinder) and the upper chamber (between the piston and the head ...
Unlike a shock absorber, a strut has a reinforced body and stem. Struts are subjected to multidirectional loads, while a shock absorber only damps vibration, only receiving a load along its axis. Struts and shock absorbers have a different way of attachment. Shock absorbers are mounted through rubber or urethane bushings to the frame and ...
While the subject is very controversial, some believe shock cooling, as commonly explained, is nothing but a myth.This position is supported by the fact twin engine planes commonly experience ideal conditions for shock cooling during simulated, single engine failures, yet statistically show no difference in wear or damage probability distribution between engines.
Vehicles with worn-out or damaged springs ride lower to the ground, which reduces the overall amount of compression available to the suspension, and increases the amount of body lean. Performance vehicles can sometimes have spring rate requirements other than vehicle weight and load.
Racal suit — a positive pressure suit with a battery-operated blower for expeditionary use. Demilitarization Protective Ensemble (DPE) — a heat-sealed, one-time-use positive pressure personnel suit. Pressure suit — the pressurized garment worn by high-altitude pilots and astronauts. Hazmat suit — unpressurized protective garment.
Strut is a common name in timber framing for a support or brace of scantlings lighter than a post. Frequently struts are found in roof framing from either a tie beam or a king post to a principal rafter. Struts may be vertically plumb or leaning (then called canted, raking, or angled) and may be straight or curved.
Surge control products have been used in many industries to protect the maximum working pressure of hydraulic system for decades. Typical applications for surge relief equipment is in pipelines at pump stations, receiving manifolds at storage facilities, back pressure control, marine loading/off loading, site specific applications where pressure surges are generated by the automation system ...
The strut will usually carry both the coil spring, on which the body is suspended, and the shock absorber, which is usually in the form of a cartridge mounted within the strut (see coilover). The strut can also have the steering arm built into the lower outer portion. The whole assembly is very simple and can be pre-assembled into a unit.