Search results
Results From The WOW.Com Content Network
IP multicast also describe IP multicast software (i.e. VideoLAN,qpimd – PIM Daemon for Quagga, GNU — PIM module for the Quagga Routing Suite, UFTP, etc.). The multicast routing is specific and broad range of protocols for layer-3 routing protocol for multicast feature and it is defined in RFC 5110. [5]
A limitation of Port Aggregation Protocol is that all the physical ports in the aggregation group must reside on the same switch. Cisco's 6500 and the 4500E platforms, remove this limitation using Virtual Switching System (VSS), [1] which allows port channels to be split between two chassis. PAgP is not supported in Cisco Nexus Switches.
MVRP, which replaced GVRP, is a standards-based Layer 2 network protocol, for automatic configuration of VLAN information on switches. It was defined in the 802.1ak amendment to 802.1Q-2005. Within a layer 2 network, MVRP provides a method to dynamically share VLAN information and configure the needed VLANs.
The multicast tree construction is receiver driven and is initiated by network nodes that are close to the receivers. IP multicast scales to a large receiver population. The IP multicast model has been described by Internet architect Dave Clark as, "You put packets in at one end, and the network conspires to deliver them to anyone who asks." [5]
The Internet Group Management Protocol (IGMP) is a communications protocol used by hosts and adjacent routers on IPv4 networks to establish multicast group memberships. IGMP is an integral part of IP multicast and allows the network to direct multicast transmissions only to hosts that have requested them.
In older Cisco IOS releases, PIM-DM would re-flood all the multicast traffic every 3 minutes. This is fine for low volume multicast, but not higher bandwidth multicast packet streams. More recent Cisco IOS versions support a new feature called PIM Dense Mode State Refresh, since 12.1(5)T.
An example of how to configure a simple, three switch MSTP topology wherein a layer-two access switch carries four VLANs and has two uplinks to two distribution switches, can be found here: MSTP Configuration Guide A good configuration view, from the above-mentioned example shall be: S3# show spanning-tree mst
It does this by utilizing either a dedicated multicast routing table or, alternatively, the router's unicast routing table. When a multicast packet enters a router's interface, the router looks up the list of networks that are reachable via that interface (i.e., it checks the paths by which the packet could have arrived).