Ad
related to: mitered corners tutorial
Search results
Results From The WOW.Com Content Network
90º miter joint (pieces ready to be joined) Miter joint of two pipes A miter joint (mitre in British English) is a joint made by cutting each of two parts to be joined, across the main surface, usually at a 45° angle, to form a corner, usually to form a 90° angle, though it can comprise any angle greater than 0 degrees.
The back of a stretched canvas, with keys inserted at the corner, and additional keys off to the side. A tightening key is a small wedge or shim used in the construction of a canvas stretcher frame with expandable joints. The key is inserted into the slotted inside the stretcher bars at the mitered corners of the frame to prevent or adjust sagging.
Mason's mitre in a kitchen countertop. A mason's mitre is a type of mitre joint, traditionally used in stonework or masonry but commonly seen in kitchen countertops.In a mason's mitre, the two elements being joined meet as for a butt joint but a small section of one member is removed creating a socket to receive the end of the other.
The earliest mitre clamps are a simple spring in a C-shape with sharpened points that are sprung onto the outside corner of the mitre joint. [citation needed]In a later design, right angled plates are higher than the screws and the holder.
Cutting inside and outside corners requires complex cuts at standard angles, typically done with powered compound miter saws that feature detents at these angles to aid the user. An alternative method, coping , is a two step process that begins with cutting a simple miter on both mating trim ends, then uses a coping saw to back-cut at least one ...
Corner bridle joint T-bridle joint. A bridle joint is a woodworking joint, similar to a mortise and tenon, in that a tenon is cut on the end of one member and a mortise is cut into the other to accept it. [1] The distinguishing feature is that the tenon and the mortise are cut to the full width of the tenon member.
An interior or exterior corner, with an angle or type of bevel, is called a "chamfer". Fillet geometry, when on an interior corner is a line of concave function , whereas a fillet on an exterior corner is a line of convex function (in these cases, fillets are typically referred to as rounds).
The symbolic representation of a V weld of chamfered plates in a technical drawing. The symbols and conventions used in welding documentation are specified in national and international standards such as ISO 2553 Welded, brazed and soldered joints -- Symbolic representation on drawings and ISO 4063 Welding and allied processes -- Nomenclature of processes and reference numbers.