Search results
Results From The WOW.Com Content Network
Four-point measurement of resistance between voltage sense connections 2 and 3. Current is supplied via force connections 1 and 4. In electrical engineering, four-terminal sensing (4T sensing), 4-wire sensing, or 4-point probes method is an electrical impedance measuring technique that uses separate pairs of current-carrying and voltage-sensing electrodes to make more accurate measurements ...
Because contact resistance is usually comparatively small, it can be difficult to measure, and four-terminal measurement gives better results than a simple two-terminal measurement made with an ohmmeter. In a two-terminal measurement (as with a typical ohmmeter), the current used to make the measurement is injected through the measurement leads ...
The operation of the Kelvin bridge is very similar to the Wheatstone bridge, but uses two additional resistors. Resistors R 1 and R 2 are connected to the outside potential terminals of the four terminal known or standard resistor R s and the unknown resistor R x (identified as P 1 and P′ 1 in the diagram).
An n-terminal network can, at best, be reduced to n impedances (at worst ()). For a three terminal network, the three impedances can be expressed as a three node delta (Δ) network or four node star (Y) network. These two networks are equivalent and the transformations between them are given below.
A circuit diagram (or: wiring diagram, electrical diagram, elementary diagram, electronic schematic) is a graphical representation of an electrical circuit. A pictorial circuit diagram uses simple images of components, while a schematic diagram shows the components and interconnections of the circuit using standardized symbolic representations.
An analog ohmmeter. An ohmmeter is an electrical instrument that measures electrical resistance (the opposition offered by a circuit or component to the flow of electric current). Multimeters also function as ohmmeters when in resistance-measuring mode. An ohmmeter applies current to the circuit or component whose resistance is to be measured.
In particular, for networks which contain only two-terminal devices, circuit topology can be viewed as an application of graph theory. In a network analysis of such a circuit from a topological point of view, the network nodes are the vertices of graph theory, and the network branches are the edges of graph theory.
Common circuit diagram symbols (US ANSI symbols) An electronic symbol is a pictogram used to represent various electrical and electronic devices or functions, such as wires, batteries, resistors, and transistors, in a schematic diagram of an electrical or electronic circuit. These symbols are largely standardized internationally today, but may ...