Ads
related to: torque converter rattle noise reduction calculator
Search results
Results From The WOW.Com Content Network
A torque converter is a device, usually implemented as a type of fluid coupling, that transfers rotating power from a prime mover, like an internal combustion engine, to a rotating driven load. In a vehicle with an automatic transmission, the torque
A capacitor, in either configuration, is used for storing BEMF for re-use and to suppress electrical and acoustic noise by limiting fluctuations in the supply voltage. If a phase is disconnected, an SR motor may continue to operate at lower torque, unlike an AC induction motor which turns off. [5] [11]
Disadvantages include high torque ripple (the difference between maximum and minimum torque during one revolution) when operated at low speed, and noise due to torque ripple. [ 1 ] Until the early twenty-first century, their use was limited by the complexity of designing and controlling them.
The torsional deflection of a simple cylinder cannot radiate efficiently acoustic noise, but with particular boundary conditions the stator can radiate acoustic noise under torque ripple excitation. [8] Structure-borne noise can also be generated by torque ripple when rotor shaft line vibrations propagate to the frame [9] and shaft line.
A direct-shift gearbox (DSG, German: Direktschaltgetriebe [1]) [2] [3] is an electronically controlled, dual-clutch, [2] multiple-shaft, automatic gearbox, in either a transaxle or traditional transmission layout (depending on engine/drive configuration), with automated clutch operation, and with fully-automatic [2] or semi-manual gear selection.
Electromagnetic interference (EMI) filters have been widely used for filtering out the conducted emissions generated by power converters since their advent. However, when size is of great concern like in aircraft and automobile applications, one of the practical solutions to suppress conducted emissions is to use random pulse-width modulation (RPWM).
Torque multipliers are often used instead of extended handles, often called "cheater bars". Extended handles use leverage instead of gear reduction to achieve torque. This torque is transmitted through the driving tool and could become dangerous in the case of a sudden catastrophic failure of the drive tool with the extended handle attached.
Direct torque control (DTC) is one method used in variable-frequency drives to control the torque (and thus finally the speed) of three-phase AC electric motors.This involves calculating an estimate of the motor's magnetic flux and torque based on the measured voltage and current of the motor.