When.com Web Search

Search results

1. Results From The WOW.Com Content Network

2. Duct (flow) - Wikipedia

   en.wikipedia.org/wiki/Duct_(flow)

   Ducts for air pollution control in a 17000 standard cubic feet per minute regenerative thermal oxidizer (RTO). A round galvanized steel duct connecting to a typical diffuser Fire-resistance rated mechanical shaft with HVAC sheet metal ducting and copper piping, as well as "HOW" (Head-Of-Wall) joint between top of concrete block wall and underside of concrete slab, firestopped with ceramic ...

3. Duct (industrial exhaust) - Wikipedia

   en.wikipedia.org/wiki/Duct_(industrial_exhaust)

   Industrial exhaust ducts are pipe systems that connect hoods to industrial chimneys through other components of exhaust systems like fans, collectors, etc. Ducts are low-pressure pneumatic conveyors to convey dust, particles, shavings, fumes, or chemical hazardous components from air in the vicinity to a shop floor or any other specific locations like tanks, sanding machines, or laboratory hoods.

4. Process duct work - Wikipedia

   en.wikipedia.org/wiki/Process_Duct_Work

   Duct slopes level to 30 degrees, 25% of cross section. Duct slopes, 30 degrees to 45 degrees, 15% of cross section; Duct Slopes, 45 degrees to 85 Degrees, 5%; Above 85 degrees, a 2 in (50 mm) interior coating of dust. These loads are always confirmed with the client, before use, but the above in US common practice

5. Fire damper - Wikipedia

   en.wikipedia.org/wiki/Fire_damper

   Interior of German mechanical fire damper inside of a galvanised steel duct. Fire dampers (or fire shutters) are passive fire protection products used in heating, ventilation, and air conditioning (HVAC) ducts to prevent and isolate the spread of fire inside the ductwork through fire-resistance rated walls and floors. [1]

6. Turning vanes (HVAC) - Wikipedia

   en.wikipedia.org/wiki/Turning_vanes_(HVAC)

   HVAC turning vanes are sheet metal devices inside of mechanical ductwork used to smoothly direct air inside a duct where there is a change in direction, by reducing resistance and turbulence. See also

7. Cable tray - Wikipedia

   en.wikipedia.org/wiki/Cable_tray

   Common cable trays are made of galvanized steel, stainless steel, aluminum, or glass-fiber reinforced plastic. The material for a given application is chosen based on where it will be used. [ 6 ] Galvanized tray may be made of pre-galvanized steel sheet fabricated into tray, or may be hot-dip galvanized after fabrication.