Ads
related to: how to adjust idle speed of a car tire chart by vehicle
Search results
Results From The WOW.Com Content Network
Idle speed, sometimes simply called "idle", is the rotational speed an engine runs at when the engine is idling, that is when the engine is uncoupled from the drivetrain and the throttle pedal is not depressed. In combustion engines, idle speed is generally measured in revolutions per minute (rpm) of the crankshaft.
Some manufacturers will install a speed governor if a vehicle is ordered with tires rated below the vehicle's maximum speed. In some parts of the European Union, e.g. Germany, it is allowed to mount tires with a lower speed rating code if the car manufacturer specifies tires with a very high speed rating in the registration documents and the ...
Idle creep, sometimes called idle speed or just creep [citation needed] is the default speed that a vehicle with an automatic transmission will move either forward or in reverse when the change lever is in D for drive or R for reverse and the foot is taken off the brake pedal but the accelerator pedal is not depressed.
The optimal speed varies with the type of vehicle, although it is usually reported to be between 35 and 50 mph (56 and 80 km/h). For instance, a 2004 Chevrolet Impala had an optimum at 42 mph (68 km/h), and was within 15 percent of that from 29 to 57 mph (47 to 92 km/h). Simple model for energy vs vehicle speed.
Tire uniformity refers to the dynamic mechanical properties of pneumatic tires as strictly defined by a set of measurement standards and test conditions accepted by global tire and car makers. These standards include the parameters of radial force variation , lateral force variation , conicity, ply steer, radial run-out , lateral run-out , and ...
Having the correct air pressure in your vehicle's tires lets your vehicle perform in the most efficient way possible. When objects such as a screw or nail puncture a tire, it creates a small leak in the tire. This leads to under-inflation of the tire. When a tire is under-inflated, it causes the inside of the tire to heat up.
In (automotive) vehicle dynamics, slip is the relative motion between a tire and the road surface it is moving on. This slip can be generated either by the tire's rotational speed being greater or less than the free-rolling speed (usually described as percent slip), or by the tire's plane of rotation being at an angle to its direction of motion (referred to as slip angle).
Tire load sensitivity describes the behaviour of tires under load. Conventional pneumatic tires do not behave as classical friction theory would suggest. The load sensitivity of most real tires in their typical operating range is such that the coefficient of friction decreases as the vertical load, Fz, increases.