Search results
Results From The WOW.Com Content Network
Architectural design optimization (ADO) is a subfield of engineering that uses optimization methods to study, aid, and solve architectural design problems, such as optimal floorplan layout design, optimal circulation paths between rooms, sustainability and the like.
A plan view of Millbank Prison, 1828. A plan is a view of a 3-dimensional object seen from vertically above (or sometimes below [citation needed]). It may be drawn in the position of a horizontal plane passing through, above, or below the object. The outline of a shape in this view is sometimes called its planform, for example with aircraft wings.
Autodesk Revit is a building information modeling software for architects, structural engineers, mechanical, electrical, and plumbing (MEP) engineers, and contractors. The original software was developed by Charles River Software, founded in 1997, renamed Revit Technology Corporation in 2000 and acquired by Autodesk in 2002.
A site plan or a plot plan is a type of drawing used by architects, landscape architects, urban planners, and engineers which shows existing and proposed conditions for a given area, typically a parcel of land which is to be modified. Sites plan typically show buildings, roads, sidewalks and paths/trails, parking, drainage facilities, sanitary ...
Plan layouts to a scale of at least 1:50, accompanied by cross-sections to a scale of at least 1:20 for all congested areas; A spatially coordinated drawing, i.e., show no physical location clashes between the system components; Allowance for inclusion of all supports and fixtures necessary to install the works
A CAGE code is a unique identifier to label an entity (that is, a specific government agency or corporation at a specific site) that is a CDA, ODA, or MFR of the part defined by the drawing. One corporation can have many CAGE codes, as can one government, because each division, department, and site (campus) can have its own CAGE code.
For each project location, building codes specify the required design wind loads. Often, a wind tunnel study is performed on large or unusually-shaped buildings. A scale model of the building and the surrounding vicinity is built and placed in a wind tunnel to determine the wind pressures acting on the structure in question.
In many places, the number of a room is determined by the number of the floor followed by two digits that inform the number of the room itself, even if there are fewer than 10 rooms per floor. This system is used in the United States by the University of Hawaiʻi at Mānoa for buildings with fewer than 99 rooms per floor. [ 4 ]