Search results
Results From The WOW.Com Content Network
Registered (Buffered) DIMM (R-DIMM or RDIMM) modules insert a buffer between the pins of the command and address buses on the DIMM and the memory chips. A high-capacity DIMM might have numerous memory chips, each of which must receive the memory address, and their combined input capacitance limits the speed at which the memory bus can operate.
The 8n prefetch architecture is combined with an interface designed to transfer two data words per clock cycle at the I/O pins. A single read or write operation for the DDR4 SDRAM consists of a single 8n-bit-wide 4-clock data transfer at the internal DRAM core and 8 corresponding n-bit-wide half-clock-cycle data transfers at the I/O pins. [20]
In computer science, a data buffer (or just buffer) is a region of memory used to store data temporarily while it is being moved from one place to another. Typically, the data is stored in a buffer as it is retrieved from an input device (such as a microphone) or just before it is sent to an output device (such as speakers); however, a buffer may be used when data is moved between processes ...
A Fully Buffered DIMM (FB-DIMM) is a type of memory module used in computer systems. It is designed to improve memory performance and capacity by allowing multiple memory modules to be each connected to the memory controller using a serial interface, rather than a parallel one.
Each screen character is represented by two bytes aligned as a 16-bit word accessible by the CPU in a single operation. The lower (or character) byte is the actual code point for the current character set, and the higher (or attribute) byte is a bit field used to select various video attributes such as color, blinking, character set, and so forth. [6]
Some ECC-enabled boards and processors are able to support unbuffered (unregistered) ECC, but will also work with non-ECC memory; system firmware enables ECC functionality if ECC memory is installed. ECC may lower memory performance by around 2–3 percent on some systems, depending on the application and implementation, due to the additional ...
Several form factors are commonly used in DIMMs. Single Data Rate Synchronous DRAM (SDR SDRAM) DIMMs were primarily manufactured in 1.5 inches (38 mm) and 1.7 inches (43 mm) heights. When 1U rackmount servers started becoming popular, these form factor registered DIMMs had to plug into angled DIMM sockets to fit in the 1.75 inches (44 mm) high ...
PC2-5300 DDR2 SO-DIMM (for notebooks) Comparison of memory modules for desktop PCs (DIMM) Comparison of memory modules for portable/mobile PCs (SO-DIMM) The key difference between DDR2 and DDR SDRAM is the increase in prefetch length.