Search results
Results From The WOW.Com Content Network
Four bolt holes and two locator pins are common to the Chevrolet and B-O-P patterns. Some transmissions, most notably the TH200-4R, take advantage of this by integrating both specifications into a "universal" bolt pattern casting.
1968–1969 Chevrolet Camaro (most were dealer installed, but in 1969 both the L-72 and the ZL-1 were factory options) 427 production codes: LS-1: produced 1969, 10.25:1 compression, Q-jet carburetor, oval port closed chamber heads, hydraulic lifters, nodular iron crankshaft, and two-bolt main caps. It produced 335 hp (250 kW). [37]
The large-journal connecting rods were thicker (heavier) and used 3 ⁄ 8 in (9.5 mm) diameter cap-bolts to replace the small-journal's 11/32. 1968 blocks were made in 2-bolt and 4-bolt versions with the 4-bolt center-three main caps each fastened by two additional bolts which were supported by the addition of thicker crankcase main-web bulkheads.
The LT-1 is a Chevrolet small-block engine produced by the Chevrolet division of General Motors between 1970 and 1972. It was available exclusively in the Corvette and Camaro and was produced in relatively small quantities. It is regarded today as one of the greatest of the Chevrolet small-blocks, an engine that has been in production since 1955.
The traditional five-bolt pentagonal cylinder head pattern was replaced with a square four-bolt design (much like the 1964–1990 Oldsmobile V8), and the pistons are of the flat-topped variety (in the LS1, LS2, LS3, LS6, LS7, LQ9, and L33), while all other variants, including the new LS9 and LQ4 truck engine, received a dished version of the GM ...
A CAGE code is a unique identifier to label an entity (that is, a specific government agency or corporation at a specific site) that is a CDA, ODA, or MFR of the part defined by the drawing. One corporation can have many CAGE codes, as can one government, because each division, department, and site (campus) can have its own CAGE code.
In 1996, a bolt-on bell housing was phased in (along with a six-bolt tailhousing) for S-10 Trucks and S-10 Blazers and beginning in 1998 for all other applications. Beginning in 1998 a new 300mm torque converter with improved higher-capacity internals, 300mm style input shaft, and 300mm style pump was also introduced on models coupled to a Gen ...
The "V" in the Corvette emblem was enlarged and gold colored, signifying the V8 engine and 12-volt electrical systems, while 6-cylinder models retained the 6-volt systems used in 1953–54. [18] Although not a part of the original Corvette project, Zora Arkus-Duntov was responsible for the addition of the V8 engine and three-speed manual ...