When.com Web Search

  1. Ads

    related to: rs232 db9 pinout signal box

Search results

  1. Results From The WOW.Com Content Network
  2. RS-232 - Wikipedia

    en.wikipedia.org/wiki/RS-232

    A DB-25 connector as described in the RS-232 standard Data circuit-terminating equipment (DCE) and data terminal equipment (DTE) network. In telecommunications, RS-232 or Recommended Standard 232 [1] is a standard originally introduced in 1960 [2] for serial communication transmission of data.

  3. Data Carrier Detect - Wikipedia

    en.wikipedia.org/wiki/Data_Carrier_Detect

    Data Carrier Detect (DCD) or Carrier Detect (CD) is a control signal present inside an RS-232 serial communications cable that goes between a computer and another device, such as a modem. This signal is a simple "high/low" status bit that is sent from a data communications equipment (DCE) to a data terminal equipment (DTE), i.e., from the modem ...

  4. Data Terminal Ready - Wikipedia

    en.wikipedia.org/wiki/Data_Terminal_Ready

    The DTR signal is present on pin 20 of the 22-wire RS-232 interface using a DB-25 connector, and on pin 4 of a newer DE-9 serial port. The signal is asserted (logic "1") by raising the voltage of the pin from negative to positive. Dropping the signal back to its negative state indicates to the modem that the communications session shall be ...

  5. Serial port - Wikipedia

    en.wikipedia.org/wiki/Serial_port

    Hardware handshaking is done with extra signals, often the RS-232 RTS/CTS or DTR/DSR signal circuits. RTS and CTS are used to control data flow, signaling, for instance, when a buffer is almost full. Per the RS-232 standard and its successors, DTR and DSR are used to signal that equipment is present and powered up so are usually asserted at all ...

  6. Serial cable - Wikipedia

    en.wikipedia.org/wiki/Serial_cable

    Serial cables are typically used for RS-232 communication. A serial cable or RS-232 cable is a cable used to transfer information between two devices using a serial communication protocol. The form of connectors depends on the particular serial port used. A cable wired for connecting two DTEs directly is known as a null modem cable.

  7. D-subminiature - Wikipedia

    en.wikipedia.org/wiki/D-subminiature

    The above naming pattern was not always followed. Because personal computers first used DB-25 connectors for their serial and parallel ports, when the PC serial port began to use 9-pin connectors, they were often labeled as DB-9 instead of DE-9 connectors, due to an ignorance of the fact that B represented a shell size. It is now common to see ...