Search results
Results From The WOW.Com Content Network
Starting fluid is sprayed into the engine intake near the air filter, or into the carburetor bore or a spark plug hole of an engine to get added fuel to the combustion cylinder quickly. Using starting fluid to get the engine running faster avoids wear to starters and fatigue to one's arm with pull start engines, especially on rarely used machines.
The greater flow rate of intake air during these conditions means that a greater quantity of blow-by gases can be added to the intake system without compromising the operation of the engine. The opening of the PCV valve during these conditions also compensates for the intake system being less effective at drawing crankcase gases into the intake ...
Typical airflow in a four-stroke engine: In stroke #1, the pistons suck in (aspirate) air to the combustion chamber through the opened inlet valve.. A naturally aspirated engine, also known as a normally aspirated engine, and abbreviated to N/A or NA, is an internal combustion engine in which air intake depends solely on atmospheric pressure and does not have forced induction through a ...
For an automobile engine the components through which the air flows to the engine cylinders, are collectively known as an intake system [4] and may include the inlet port and valve. [5] An intake for a hydroelectric power plant is the capture area in a reservoir which feeds a pressure pipe, or penstock , or into an open canal.
Engine oil is recirculated around a four-stroke engine (rather than burning it as happens in a two-stroke engine) and much of this occurs within the crankcase. Oil is stored either at the bottom of the crankcase (in a wet sump engine) or in a separate reservoir (in a dry sump system). [ 3 ]
A valvetrain is a mechanical system that controls the operation of the intake and exhaust valves in an internal combustion engine. [1] The intake valves control the flow of air/fuel mixture (or air alone for direct-injected engines) into the combustion chamber, while the exhaust valves control the flow of spent exhaust gases out of the ...
Diagram of a typical gas turbine jet engine. Air is compressed by the compressor blades as it enters the engine, and it is mixed and burned with fuel in the combustion section. The hot exhaust gases provide forward thrust and turn the turbines which drive the compressor blades. 1. Intake 2. Low pressure compression 3. High pressure compression ...
In most steam engine designs there is a short time at the end of the return stroke of the piston when all the valves are shut and it is compressing any remaining steam. Water can be introduced from the boiler or in a cold engine, steam will condense to water on the cool walls of the cylinders and can potentially hydrolock an engine.