Ads
related to: 1 female 2 male splitter connector with 3 parts catalogsweetwater.com has been visited by 100K+ users in the past month
Search results
Results From The WOW.Com Content Network
Example part numbers are any of TE Connectivity / AMP 170204-* (loose pieces) or 170262-* (pieces supplied in strips), where * is 1 or 2 or 4. [2] [3] The male PCB connector on the 3½-inch floppy drive is normally a polarized right-angle male header, which is a TE Connectivity / AMP 171826-4, [4] the straight model is AMP 171825-4. [5]
The connector typically has 2 to 24 contacts and is polarized or keyed to ensure correct orientation. Pins and sockets can be arranged in any combination in a single housing, and each housing can be either male or female. There are three typical pin sizes: 1.57 mm (0.062 in), 2.13 mm (0.084 in), and 2.36 mm (0.093 in).
A Shure FP24 preamp's mono XLR line outputs connected to an Edirol R-09 recorder's 3.5mm stereo jack line input, using a Y-cable. This is an example of consolidating connectors, as described below. A Y-cable, Y cable, or splitter cable is a cable with three ends: one common end and two other ends.
It is very common in blogs and websites to incorrectly name a specific connector only by the name of the manufacturer. To minimize confusion, it is best to describe a connector using: the manufacturer's name, exact connector series, and optionally the pitch, such as "JST-XH" or "JST-XH-2.50mm" or "2.50mm JST XH-series" or other variations.
Six series are covered in one of TE's catalogs (which omits the 0.375 in/9.5 mm, but mentions it elsewhere), named after their blade width in mils. [3] Insulated versions of the terminals are color-coded to indicate what wire gauges they may be used with. The terminal system consists of tabs (male) and receptacles (female).
SMA connectors must not be confused with the standard household 75-ohm type F coax connector (diameters: male 7 ⁄ 16 inch (11 mm) circular or hex; female 3 ⁄ 8 inch (9.5 mm) external threads), as there is only about a 2 mm difference overall in the specifications. Type F cannot be mated with SMA connectors without the use of an adapter.