Search results
Results From The WOW.Com Content Network
For example, resistors, capacitors, and inductors are linear, while diodes and transistors are nonlinear. An I–V curve which is a straight line through the origin with positive slope represents a linear or ohmic resistor, the most common type of resistance encountered in circuits.
Mixed-mode simulation is handled on three levels: with primitive digital elements that use timing models and the built-in 12 or 16 state digital logic simulator, with subcircuit models that use the actual transistor topology of the integrated circuit, and finally, with inline Boolean logic expressions.
A capacitance multiplier is designed to make a capacitor function like a much larger capacitor. This can be achieved in at least two ways. An active circuit, using a device such as a transistor or operational amplifier; A passive circuit, using autotransformers. These are typically used for calibration standards.
Transmission lines are a common example of the use of the distributed model. Its use is dictated because the length of the line will usually be many wavelengths of the circuit's operating frequency. Even for the low frequencies used on power transmission lines, one-tenth of a wavelength is still only about 500 kilometres at 60 Hz.
Digital circuit responses are often used to populate databases for signal delay and loading calculation such as: timing analysis; power analysis; circuit simulation; and signal integrity analysis. Analog circuits are often run in detailed test benches to indicate if the extra extracted parasitics will still allow the designed circuit to function.
The simplest switched-capacitor (SC) circuit is made of one capacitor and two switches S 1 and S 2 which alternatively connect the capacitor to either in or out at a switching frequency of . Recall that Ohm's law can express the relationship between voltage, current, and resistance as:
Mixed-mode simulation is handled on three levels by CircuitLogix: (a) with primitive digital elements that use timing models and a built-in 12-state digital logic simulator, (b) with subcircuit models that use the actual transistor topology of the integrated circuit, and finally, (c) with In-line Boolean logic expressions. These two modeling ...
In August 1981, the analog equivalent of the first program, Circuit Designer and Simulator, was released. Its integrated text editor created circuit descriptions for a simple, linear, analog simulator. September 1982 saw the release of the first Micro-Cap package as a successor to the Circuit Designer and Simulator. 1982 Micro-Cap; 1984 Micro-Cap 2