Ads
related to: installing coaxial cable ends replacement parts video
Search results
Results From The WOW.Com Content Network
Generally use coaxial cable types such as RG-6 and RG-59 (except for twin-lead). Belling-Lee/IEC 169-2 connector TV aerial plug (a.k.a. antenna plug) Television antenna connection for most video devices outside North America. Used by early home computers and game consoles to connect them to TVs because of the lack of any other connector.
Cable-ready television sets have coaxial cable F connectors. One end connects to the cable, antenna, or VHF jack on the back of the television set; the other end connects to the wall CATV outlet. Once the television is connected through the cable to the wall CATV outlet, the television will need to be programmed to receive the cable channels.
The terminator is usually placed at the end of a transmission line or daisy chain bus (such as in SCSI), and is designed to match the AC impedance of the cable and hence minimize signal reflections, and power losses. Less commonly, a terminator is also placed at the driving end of the wire or cable, if not already part of the signal-generating ...
RG-59 coaxial cable is commonly packed with consumer equipment, such as VCRs or digital cable/satellite receivers. Manufacturers tend to include only RG-59 cables because it costs less than RG-6 does. However, given the short lengths provided (usually 4–6 ft or 1.2–1.8 m), this is generally sufficient for its typical use.
Rear of a video switcher with an array of BNC connectors. The BNC was originally designed for military use and has gained wide acceptance in video and RF applications up to 2 GHz. BNC connectors are used with miniature-to-subminiature coaxial cable in radio, television, and other radio-frequency electronic equipment.
The coaxial cable center conductor forms the pin, and cable dielectric extends up to the mating face of the connector. Thus, the male connector consists of only a body, which is generally crimped onto or screwed over the cable shielding braid, and a captive nut, neither of which require tight tolerances.