Search results
Results From The WOW.Com Content Network
The Chevrolet HHR (an initialism for Heritage High Roof) [1] is a retro-styled, high-roofed, five-door, five-passenger, front-wheel drive wagon [2] [3] designed by Bryan Nesbitt and launched by the American automaker Chevrolet [4] at the 2005 Los Angeles Auto Show [citation needed] as a 2006 model.
A wheel cylinder is a component of a hydraulic drum brake system. [1] It is located in each wheel and is usually positioned at the top of the wheel, above the shoes. Its function is to exert force onto the shoes so as to bring them into contact with the drum and stop the vehicle with friction . [ 2 ]
Drum brake (upper right) with the drum removed (lower left, inside facing up), on the front of a Ford Falcon Sprint A rear drum brake on a Kawasaki W800 motorcycle. A drum brake is a brake that uses friction caused by a set of shoes or pads that press outward against a rotating bowl-shaped part called a brake drum.
US 2544849 Hydraulic brake automatic adjuster. Martin 1951-03-13; US 2485032 Brake apparatus. Bryant 1949-10-08; US 2466990 Single disk brake. Johnson Wade C, Trishman Harry A, Stratton Edgar H. 1949-04-12; US 2416091 Fluid pressure control mechanism. Fitch 1947-02-12; US 2405219 Disk brake. Lambert Homer T. 1946-08-06; US 2375855 Multiple disk ...
An S-cam is part of a braking system used in heavy vehicles such as trucks and wheeled machinery. It consists of a shaft, usually around 4 to 25 inches long, turned at one end by means of an air-powered brake booster and lever with an S-shaped cam at the wheel end.
The concept of brake pads or disc brakes as an alternative to drum brakes had been around at least as early as a patent by F. W. Lanchester in 1902. [2] However, due to high cost and inefficiencies compared to drum brakes they were not commonly implemented until after World War II. [3]
This secondary drum parking brake is often referred to as a banksia brake. It is usually used in conjunction with rear disc brakes employing multi-piston calipers, as mechanically actuating these calipers is more difficult than single piston calipers. Another less common setup for rear discs is the use of a separate, smaller, cable actuated ...
As train loads, gradients and speeds increased, braking became a more significant problem. In the late 19th century, significantly better continuous brakes started to appear. The earliest type of continuous brake was the chain brake [19] which used a chain, running the length of the train, to operate brakes on all vehicles simultaneously.