Search results
Results From The WOW.Com Content Network
A PV solar-powered pump system has three main parts - one or more solar panels, a controller, and a pump.The solar panels make up most (up to 80%) of the system's cost. [citation needed] The size of the PV system is directly dependent on the size of the pump, the amount of water that is required, and the solar irradiance available.
Warman centrifugal pump in a coal preparation plant application A pair of centrifugal pumps for circulating hot water within a hydronic heating system. Centrifugal pumps are used to transport fluids by the conversion of rotational kinetic energy to the hydrodynamic energy of the fluid flow. The rotational energy typically comes from an engine ...
A pulser pump makes use of water that flows through pipes and an air chamber from an upper reservoir to a lower reservoir. The intake is a trompe, which uses water flow to pump air to a separation chamber; air trapped in the chamber then drives an airlift pump. The top of the pipe that connects the upper reservoir to the air chamber is ...
The device uses the water hammer effect to develop pressure that allows a portion of the input water that powers the pump to be lifted to a point higher than where the water originally started. The hydraulic ram is sometimes used in remote areas, where there is both a source of low-head hydropower and a need for pumping water to a destination ...
Booster pumps for household water pressure are usually simple electrically driven centrifugal pumps with a non-return valve. They may be constant speed pumps which switch on when pressure drops below the low pressure set-point and switch off when pressure reaches the high set-point, or variable speed pumps which are controlled to maintain a ...
A chain pump is a type of water pump that uses a chain to move water from one place to another. It works on the principle of a continuous loop of chain moving through a series of sprockets, with attached buckets that lift water as the chain passes over the top sprocket and discharge it as the chain reaches the bottom.
The diaphragm or bladder may itself exert a pressure on the water, but it is usually small and will be neglected in the following discussion. Case 1 is an empty tank at the charging pressure P c (gauge). The total volume of the tank is V t. Case 2 is a tank in use, with the air pressure at pressure P (gauge) and a water volume of V
A stirrup pump is a portable reciprocating water pump used to extinguish or control small fires. [1] It is operated by hand. The operator places a foot on a stirrup-like bracket at the bottom of the pump to hold the pump steady, the bottom of the suction cylinder is placed inside a bucket of water.