Search results
Results From The WOW.Com Content Network
Wood will expand and contract across the grain, and a wide panel made of solid wood could change width by a half of an inch, warping the door frame. By allowing the wood panel to float, it can expand and contract without damaging the door. A typical panel would be cut to allow 1/4" (5 mm) between itself and the bottom of the groove in the frame.
A diagram illustrating the components of a panel door. When framed in wood for snug fitting of a door, the doorway consists of two vertical jambs on either side, a lintel or head jamb at the top, and perhaps a threshold at the bottom. When a door has more than one movable section, one of the sections may be called a leaf.
Three point lock are also commonly used in wardrobes, like from Hettich [6] [7] Single-point locking may provide adequate security for some situations on tiered lockers, as the doors are shorter, and therefore more difficult to force open; however, the taller doors of full length lockers and cabinets are more susceptible to the application of leverage.
The plug is machined to accept a typical bottom bracket, but offset from the center of the plug, so that by rotating the plug, the location of the bottom bracket (and hence the chain tension) may be adjusted (fore and aft to tension the chain, the upper or lower eccentric position for a given chain length can be chosen to fine tune bottom ...
Tupperware expanded to Europe in 1960 when Mila Pond hosted Tupperware parties in Weybridge, England, and other locations around the world. [19] A comparison technique called "carrot calling" was used by the representatives wherein they would travel door-to-door in a neighborhood and ask housewives to compare carrots placed in a Tupperware container with anything that they would have ...
In modern wood construction, sills usually come in sizes of 2×4, 2×6, 2×8, and 2×10. In stick framing, the sill is made of treated lumber, and is anchored to the foundation wall, often with J-bolts, to keep the building from coming off the foundation during a severe storm or earthquake. Building codes require that the bottom of the sill ...
A drawbar is a defensive implement used to secure a door or gate in a medieval or Early Modern building such as a castle, [1] [2] but also churches and townhouses. When drawn across the full length of the door, it prevents the door or gate from being opened. To open the door or gate, the drawbar is pushed into a drawbar slot in the wall.
Wall studs are framing components in timber or steel-framed walls, that run between the top and bottom plates.It is a fundamental element in frame building. The majority non-masonry buildings rely on wall studs, with wood being the most common and least-expensive material used for studs.