Search results
Results From The WOW.Com Content Network
Previous stresses and other changes in a soil's history are preserved within the soil's structure. [4] If a soil is loaded beyond this point the soil is unable to sustain the increased load and the structure will break down. [4] This breakdown can cause a number of different things depending on the type of soil and its geologic history.
In geotechnical engineering, soil compaction is the process in which stress applied to a soil causes densification as air is displaced from the pores between the soil grains. When stress is applied that causes densification due to water (or other liquid) being displaced from between the soil grains, then consolidation , not compaction, has ...
The test is named in honor of Ralph Roscoe Proctor , who in 1933 showed that the dry density of a soil for a given compactive effort depends on the amount of water the soil contains during soil compaction. [1] His original test is most commonly referred to as the standard Proctor compaction test; his test was later updated to create the ...
These tests are used to determine the maximum unit weight and optimal water content a soil can achieve for a given compaction effort. Soil suction tests ASTM D5298. Triaxial shear tests This is a type of test that is used to determine the shear strength properties of a soil. It can simulate the confining pressure a soil would see deep into the ...
Based on this history it has also been called the "Dutch cone test". Today, the CPT is one of the most used and accepted soil methods for soil investigation worldwide. The test method consists of pushing an instrumented cone , with the tip facing down, into the ground at a controlled rate (controlled between 1.5 -2.5 cm/s accepted).
The standard penetration test (SPT) is an in-situ dynamic penetration test designed to provide information on the geotechnical engineering properties of soil. This test is the most frequently used subsurface exploration drilling test performed worldwide. The test procedure is described in ISO 22476-3, ASTM D1586 [1] and Australian Standards AS ...
If the soil particles in a sample are predominantly in a relatively narrow range of sizes, the sample is uniformly graded. If a soil sample has distinct gaps in the gradation curve, e.g., a mixture of gravel and fine sand, with no coarse sand, the sample may be gap graded. Uniformly graded and gap graded soils are both considered to be poorly ...
The consolidation cell is the part of the oedometer that holds the soil sample during a test. At the centre of the consolidation cell is a sample ring where the soil sample is held. The sample ring is typically shaped like a cookie cutter , with a sharp edge on one side, so the ring can be used to cut out a sample slice of soil from a larger ...