Ads
related to: dependent suspension system for cars reviews and ratings
Search results
Results From The WOW.Com Content Network
An active suspension is a type of automotive suspension that uses an onboard control system to control the vertical movement of the vehicle's wheels and axles relative to the chassis or vehicle frame, rather than the conventional passive suspension that relies solely on large springs to maintain static support and dampen the vertical wheel movements caused by the road surface.
Van Diemen RF01 Racing Car Suspension. Suspension is the system of tires, tire air, springs, shock absorbers and linkages that connects a vehicle to its wheels and allows relative motion between the two. [1] Suspension systems must support both road holding/handling and ride quality, [2] which are at odds with each other. The tuning of ...
As such, push-rod suspension systems allow for much greater high-speed stability, much lower levels of body-roll, and a much lower centre of gravity for the vehicle. [7] For pull-rod suspension systems, the only difference is the orientation of the rocker arms. In a push-rod system, the rocker arms are placed at the highest point in the assembly.
A beam axle, rigid axle, or solid axle is a dependent suspension design in which a set of wheels is connected laterally by a single beam or shaft. Beam axles were once commonly used at the rear wheels of a vehicle, but historically, they have also been used as front axles in four-wheel-drive vehicles.
MagneRide is an automotive adaptive suspension with magnetorheological damper system developed by the Delphi Automotive corporation, [1] [2] that uses magnetically controlled dampers, or shock absorbers, for a highly adaptive ride. As opposed to traditional suspension systems, MagneRide has no mechanical valves or even small moving parts that ...
Pages in category "Automotive suspension technologies" The following 88 pages are in this category, out of 88 total. This list may not reflect recent changes .
Automotive suspension design is an aspect of automotive engineering, concerned with designing the suspension for cars and trucks. Suspension design for other vehicles is similar, though the process may not be as well established. The process entails Selecting appropriate vehicle level targets; Selecting a system architecture
The semi-active suspension system was widely used on luxury and top sport trim packages on most of Toyota's products sold internationally. Its popularity fell after the “ bubble economy ” as it was seen as an unnecessary expense to purchase and maintain, and remained in use on luxury or high performance sports cars.