Ad
related to: high density polyethylene melting point
Search results
Results From The WOW.Com Content Network
HDPE is known for its high strength-to-density ratio. [4] The density of HDPE ranges from 930 to 970 kg/m 3. [5] Although the density of HDPE is only marginally higher than that of low-density polyethylene, HDPE has little branching, giving it stronger intermolecular forces and tensile strength (38 MPa versus 21 MPa) than LDPE. [6]
The melting point for average commercial low-density polyethylene is typically 105 to 115 °C (221 to 239 °F). These temperatures vary strongly with the type of polyethylene, but the theoretical upper limit of melting of polyethylene is reported to be 144 to 146 °C (291 to 295 °F). Combustion typically occurs above 349 °C (660 °F).
Interest in the material in the 1950s arose from its high melting point and tensile strength, making it more desirable than the more common form of polyethylene. For example, the medical community in 1958 was eager to use Marlex 50 crystalline polyethylene which softens at 260 °F (127 °C).
Ultra-high-molecular-weight polyethylene (UHMWPE, UHMW) is a subset of the thermoplastic polyethylene. Also known as high-modulus polyethylene ( HMPE ), it has extremely long chains, with a molecular mass usually between 3.5 and 7.5 million amu . [ 1 ]
High-density polyethylene: 70–80: 1.0: 0.85 Low-density polyethylene: ... or in samples stored for long time at temperatures just under the melting point. The ...
A cross-linked polyethylene (PEX) pipe. Cross-linked polyethylene, commonly abbreviated PEX, XPE or XLPE, is a form of polyethylene with cross-links.It is used predominantly in building services pipework systems, hydronic radiant heating and cooling systems, domestic water piping, insulation for high tension (high voltage) electrical cables, and baby play mats.
Above its glass transition temperature and below its melting point, ... High-density polyethylene (HDPE), recyclable plastic no. 2, is commonly used as milk jugs, ...
Melt flow rate is very commonly used for polyolefins, polyethylene being measured at 190 °C and polypropylene at 230 °C. The plastics engineer should choose a material with a melt index high enough that the molten polymer can be easily formed into the article intended, but low enough that the mechanical strength of the final article will be ...