Search results
Results From The WOW.Com Content Network
ping is a computer network administration software utility used to test the reachability of a host on an ... it lists the statistics of the entire test. In this ...
The advantages of PathPing over ping and traceroute are that each node is pinged as the result of a single command, and that the behavior of nodes is studied over an extended time period, rather than the default ping sample of four messages or default traceroute single route trace. The disadvantage is that it takes a total of 25 seconds per hop ...
An ATM network interface in the form of an accessory card. A lot of network interfaces are built-in. A network interface controller (NIC) is computer hardware that connects the computer to the network media and has the ability to process low-level network information. For example, the NIC may have a connector for plugging in a cable, or an ...
The round-trip time or ping time is the time from the start of the transmission from the sending node until a response (for example an ACK packet or ping ICMP response) is received at the same node. It is affected by packet delivery time as well as the data processing delay , which depends on the load on the responding node.
Paping (pronounced pah ping) is a computer network administration utility used to test the reachability of a host on an Internet Protocol (TCP/IP) network and to measure the time it takes to connect to a specified port. The name is a play on the word ping, another computer network administration utility.
RTT is a measure of the amount of time taken for an entire message to be sent to a destination and for a reply to be sent back to the sender. The time to send the message to the destination in its entirety is known as the network latency, and thus RTT is twice the latency in the network plus a processing delay at the destination. The other ...
Returns statistics about the size of the network. [16] If called with no arguments, the statistics will reflect the entire network. If <mask> is given, it will return only statistics reflecting the masked subset of the network. If <target> is given, the command will be forwarded to <server> for evaluation. Defined in RFC 2812.
Reasons for measuring throughput in networks. People are often concerned about measuring the maximum data throughput in bits per second of a communications link or network access. A typical method of performing a measurement is to transfer a 'large' file from one system to another system and measure the time required to complete the transfer or ...