Search results
Results From The WOW.Com Content Network
Subtension refers to the length between two points on a target, and is usually given in either centimeters, millimeters or inches. Since an mrad is an angular measurement, the subtension covered by a given angle (angular distance or angular diameter) increases with viewing distance to the target. For instance the same angle of 0.1 mrad will ...
Larger units of length Unit Greek name Equal to Modern equivalent Description pous πούς: 0.308 m (1.01 ft) foot haploun bēma [4] ἁπλοῦν βῆμα: 2 + 1 ⁄ 2 podes 0.77 m (2.5 ft) step bēma, [3] diploun bēma [4] βῆμα, διπλοῦν βῆμα: 5 podes 1.54 m (5.1 ft) pace: orgyia ὄργυια: 6 podes 1.85 m (6.1 ft) fathom
The former Weights and Measures office in Seven Sisters, London Units of measurement, Palazzo della Ragione, Padua. A unit of measurement, or unit of measure, is a definite magnitude of a quantity, defined and adopted by convention or by law, that is used as a standard for measurement of the same kind of quantity. [1]
The codes given in the chart below usually tell the length and width of the components in tenths of millimeters or hundredths of inches. For example, a metric 2520 component is 2.5 mm by 2.0 mm which corresponds roughly to 0.10 inches by 0.08 inches (hence, imperial size is 1008).
If one looks at a one-centimeter object at a distance of one meter and a two-centimeter object at a distance of two meters, both subtend the same visual angle of about 0.01 rad or 0.57°.
A small number of gauge blocks can be used to create accurate lengths within a wide range. By using three blocks at a time taken from a set of 30 blocks, one may create any of the 1000 lengths from 3.000 to 3.999 mm in 0.001 mm steps (or .3000 to .3999 inches in 0.0001 inch steps).
A set of pins from 1.550 to 6.725 mm. The associated image is a set of pin gauges used to measure holes only a few millimeters in diameter. Pin gauges come in many classes and X, XX, ZZ, are a few examples. They are Go and NO Go pins, these pins can al
Many non-proprietary co-axial power plugs are 5.5 mm (0.22 in) in outside diameter (OD) and 9.5 mm (0.37 in) in length. Two pin sizes are standard in the jacks for this size plug body, 2.1 mm (0.083 in) and 2.5 mm (0.098 in), and the plugs should match.