Ads
related to: 50 pin connector pinout image
Search results
Results From The WOW.Com Content Network
A cable could have 5.25-inch style connectors, 3.5-inch style connectors, or a combination. After IBM introduced the "twist" to floppy cables, and when both 5.25-inch and 3.5-inch drives were in common use, many cables had four connectors: one of each type before the twist, and one of each type after the twist.
SCSI hard drives showing 80-pin SCA connector (top), and separate 68-pin and power connectors plus configuration jumpers (bottom) SCSI backplane with 80-pin SCA connectors. Hard Drives are mounted on proprietary hot-swappable caddies. Single Connector Attachment, or SCA, is a type of connection for the internal cabling of Parallel SCSI systems ...
1 Mini-DIN 4-pin, 1 Mini-DIN 7-pin, 1 Mini-VGA, 2 BNC, 2 RCA connectors, 8-pin DIN, [4] SCART 21-pin: S-VHS, some laptop computers, analog broadcast video, 1980-1990s home computers including the Commodore 64, C128 and Atari 8-bit computers: The 4-pin mini-DIN that is most common in consumer products today debuted in JVC's 1987 S-VHS. The 7-pin ...
Accelerated Graphics Port connector pinout [13]: 95 [15]: 231–3 [16]: 50 Pin Side B Side A Comments 1 OVERCNT# +12 V: USB port overcurrent warning 2 +5 V: TYPEDET# Pulled low by card to indicate 1.5 V (AGP 2.0 4x) ability 3 +5 V: GC_DET# Pulled low by card to indicate 0.8 V (AGP 3.0 8x) ability 4 USB+: USB−
A cable with a 50-pin connector on one end can support six fully wired 8P8C connectors or Ethernet ports on a patch panel with one spare pair. Alternatively, only the necessary pairs for 10/100 Ethernet can be wired allowing twelve Ethernet ports with a single spare pair. This connector is also used with spring bail locks for SCSI-1 connections.
The interface dimensions for SMA connectors are listed in MIL-STD-348. [5] The SMA connector employs a 1 ⁄ 4 inch diameter, 36-thread-per-inch threaded barrel. The male is equipped with a hex nut measuring 5 ⁄ 16 inch (0.3125 inch / 7.9 mm) across opposite flats, thus taking the same wrench as a #6 SAE hex nut.
Starting with the 80-conductor cable defined for use in ATAPI5/UDMA4, the master Device 0 device goes at the far-from-the-host end of the 18-inch (460 mm) cable on the black connector, the slave Device 1 goes on the grey middle connector, and the blue connector goes to the host (e.g. motherboard IDE connector, or IDE card).
All Apple II models except the Apple IIc had at least seven 50-pin expansion slots, labeled Slots 1 though 7. These slots could hold printed circuit board cards with double-sided edge connectors, 25 "fingers" on each side, with 100 mil (0.1 inch) spacing between centers.