Search results
Results From The WOW.Com Content Network
The board foot or board-foot is a unit of measurement for the volume of lumber in the United States and Canada [1].It equals the volume of a board that is one foot (30.5 cm) in length, one foot in width, and one inch (2.54 cm) in thickness, or exactly 2.359 737 216 liters.
A standard metric (concrete) block is 190 mm wide, 390 mm long, and 190 mm high, which allows for 10 mm mortar joints in between bricks, giving a standard unit size of 200 mm square by 400 mm long. [3] A standard metric brick is 90 by 57 by 190 mm; with 10 mm of mortar, that produces a standard unit of 100 mm x 200 mm. [3]
As previously noted, less wood is needed to produce a given finished size than when standards called for the green lumber to be the full nominal dimension. However, even the dimensions for finished lumber of a given nominal size have changed over time. In 1910, a typical finished 1-inch (25 mm) board was 13 ⁄ 16 in (21 mm). In 1928, that was ...
This has allowed new construction to become less expensive without having to modify municipal, state, and national building codes. [citation needed] Now, it's true that many buildings (say, ca. 1900 in the U.S.) do use rough-cut lumber, with the "real" dimensions, i.e. a 2x4 is actually 2"x4".
Wall framing in house construction includes the vertical and horizontal members of exterior walls and interior partitions, both of bearing walls and non-bearing walls. . These stick members, referred to as studs, wall plates and lintels (sometimes called headers), serve as a nailing base for all covering material and support the upper floor platforms, which provide the lateral strength along a
Steel studs are gaining popularity as a non-combustible alternative, especially for non load-bearing walls, and are required in some firewalls. In New Zealand, the required lumber size and spacing of wall studs are determined using NZS 3604 Timber-framed buildings table 8.2 for loadbearing walls and table 8.4 for non-loadbearing walls. [4]
From IT6 to IT18, the standard tolerances are multiplied by the factor 10 at each fifth step. This rule applies to all standard tolerances and may be used to extrapolate values for IT grades not given in Table 1. For example, the nominal size range 120 mm up to and including 180 mm, the value of IT20 is: IT20 = IT15 × 10 = 1.6 mm × 10 = 16 mm [2]
Also rendered as 2x4. A common size of dimensional lumber named for its unprocessed dimensions, usually measuring 1.5 by 3.5 inches (3.8 cm × 8.9 cm) in practice. U