Search results
Results From The WOW.Com Content Network
7.853 982 × 10 −7 in 2 A circular mil is a unit of area , equal to the area of a circle with a diameter of one mil (one thousandth of an inch or 0.0254 mm). It is equal to π /4 square mils or approximately 5.067 × 10 −4 mm 2 .
Converts measurements to other units. Template parameters [Edit template data] This template prefers inline formatting of parameters. Parameter Description Type Status Value 1 The value to convert. Number required From unit 2 The unit for the provided value. Suggested values km2 m2 cm2 mm2 ha sqmi acre sqyd sqft sqin km m cm mm mi yd ft in kg g mg lb oz m/s km/h mph K C F m3 cm3 mm3 L mL cuft ...
{{convert|100|Mm|mm}} → 100 megametres (1.0 × 10 11 mm) The output of {{convert}} can display multiple converted units, if further unit-codes are specified after the second unnamed parameter (without the pipe separator). Typical combination output units are listed below in column 7. {{convert|55|nmi|km mi}} → 55 nautical miles (102 km; 63 mi)
kgf/mm 2: ≡ 1 kgf/mm 2 = 9.806 65 × 10 6 Pa [33] kip per square inch: ksi ≡ 1 kipf/sq in ≈ 6.894 757 × 10 6 Pa [33] long ton per square foot: ≡ 1 long ton × g 0 / 1 sq ft ≈ 1.072 517 801 1595 × 10 5 Pa: micrometre of mercury: μmHg ≡ 13 595.1 kg/m 3 × 1 μm × g 0 ≈ 0.001 torr ≈ 0.133 3224 Pa [33] millimetre of mercury ...
Nominal Pipe Size (NPS) is a North American set of standard sizes for pipes used for high or low pressures and temperatures. [1] " Nominal" refers to pipe in non-specific terms and identifies the diameter of the hole with a non-dimensional number (for example – 2-inch nominal steel pipe" consists of many varieties of steel pipe with the only criterion being a 2.375-inch (60.3 mm) outside ...
Thickness of aluminum foil is measured in mils (1 ⁄ 1000 inch, or 0.0254 mm) in the United States. Cross-sectional area of electrical wire is measured in circular mils in the U.S. and Canada, one circular mil (cmil) being equal to 5.067 × 10 −4 mm 2 (or 7.854 × 10 −7 in 2). Since this is so small, actual wire is commonly measured in ...
The basic module (M) is a unit of distance equal to one hundred millimetres (100 mm). The myriametre (mym) is a unit of distance equal to ten kilometres (10 km). The hebdometre is a unit of distance equal to ten megametres (10 Mm). The spat (S) is a unit of distance equal to one terametre (1 Tm).
The ultimate tensile strength of a material is an intensive property; therefore its value does not depend on the size of the test specimen.However, depending on the material, it may be dependent on other factors, such as the preparation of the specimen, the presence or otherwise of surface defects, and the temperature of the test environment and material.