When.com Web Search

Search results

1. Results From The WOW.Com Content Network

2. Metal hose - Wikipedia

   en.wikipedia.org/wiki/Metal_hose

   Stainless steel models have a temperature resistance of up to approx. 600 °C, depending on the pressure load, and even higher values are possible with special materials. In the low temperature range, stainless steel corrugated hoses can be used down to -270 °C.

3. Braided stainless steel brake lines - Wikipedia

   en.wikipedia.org/wiki/Braided_stainless_steel...

   Braided stainless steel brake lines (also known as braided stainless steel brake hoses) are flexible hoses fitted to a hydraulic brake system. The intent of braided stainless steel brake lines is to improve brake system effectiveness and longevity as compared to an equivalent system fitted with flexible rubber hoses through near-elimination of hose expansion.

4. Piping and plumbing fitting - Wikipedia

   en.wikipedia.org/wiki/Piping_and_plumbing_fitting

   These pipe clamps are similar to hose clamps, but are heavier-duty and ideally are made completely of stainless steel (including the screw) to provide maximum service life. [ 21 ] : 149 [ 18 ] : 71 Optionally, the entire rubber sleeve may be jacketed with thin sheet metal, to provide extra stiffness, durability, and resistance to accidental ...

5. Hose - Wikipedia

   en.wikipedia.org/wiki/Hose

   Early hoses were made of leather, although modern hoses are typically made of rubber, canvas, and helically wound wire. Hoses may also be made from plastics such as polyvinyl chloride, polytetrafluoroethylene, and polyethylene terephthalate, or from metals such as stainless steel. [2]

6. Hose clamp - Wikipedia

   en.wikipedia.org/wiki/Hose_clamp

   The hose is then fit onto the barb, the clamp expanded again, slid onto the portion of the hose over the barb, then released, compressing the hose onto the barb. Clamps of this design are rarely used for high pressures or large hoses, as they would require unwieldy amounts of steel to generate enough clamping force, and be impossible to work ...

7. American Radiator Company - Wikipedia

   en.wikipedia.org/wiki/American_Radiator_Company

   The American Radiator company was formed in 1892 from the Detroit Radiator Company, the Michigan Radiator & Iron Manufacturing Company, and the Pierce Steam Heating Company of Buffalo. [ 2 ] [ 1 ] The company was headed by Joseph Bond, (of Pierce Steam Heating Co.), as president, Charles Hodges, (of Detroit Radiator) as treasurer, and Clarence ...