Search results
Results From The WOW.Com Content Network
The de facto standard for 3.5 inch drives uses a 34-pin header mating to an IDC Berg connector, collectively slightly smaller than the PCB edge pin connector and mating socket used for the 5¼ inch standard but with the same 34 pin definitions as the 5¼ inch standard. [7] A separate connector is provided for DC power. [1]
Many types of Berg connectors exist. Some of the more familiar ones used in IBM PC compatibles are: the four-pin polarized Berg connectors used to connect 3½-inch floppy disk drive units to the power supply unit, usually referred to as simply a "floppy power connector", but often also referred to as LP4. This connector has a 2.50 mm (0.098 in ...
When the controller and disk drive are assembled as one device, as it is the case with some external floppy disk drives, e.g., Commodore 1540 and USB floppy disk drives, [27] the internal floppy disk drive and its interface are unchanged, while the assembled device presents a different interface such as IEEE-488, parallel port or USB.
Main page; Contents; Current events; Random article; About Wikipedia; Contact us
English: Diagram illustrating the basic internal parts of a 3.5" floppy disk. Document labels rendered as numbers to aid in internationalization. Note: The unlabeled square in the upper left is the approximate location of the write protection tab.
The ST-506 and ST-412 (sometimes written ST506 and ST412 [1]) were early hard disk drive products introduced by Seagate in 1980 and 1981 respectively, [1] that later became construed as hard disk drive interfaces: the ST-506 disk interface and the ST-412 disk interface. Introduced in 1980, the ST-506 was the first 5.25 inch HDD.
A disk controller is a controller circuit that enables a CPU to communicate with a hard disk, floppy disk or other kind of disk drive. It also provides an interface between the disk drive and the bus connecting it to the rest of the system. [1] [2] Early disk controllers were identified by their storage methods and data encoding.
The WD1761-WD1767 series were versions of the FD179x series rated for a maximum clock frequency of 1 MHz, resulting in a data rate limit of 125 kbit/s for single density and 250 kbit/s for double density, thus preventing them from being used for 8-in (200 mm) floppy drives or the later "high-density" 5.25-inch (133 mm) or 90 mm floppy drives.