Search results
Results From The WOW.Com Content Network
A sound with a loudness of 1 sone is judged equally loud as a 1 kHz tone with a sound pressure level of 40 decibels above 20 micropascals. [1] The phon is psychophysically matched to a reference frequency of 1 kHz. [2] In other words, the phon matches the sound pressure level in decibels of a similarly perceived 1 kHz pure tone. [3]
An equal-loudness contour is a measure of sound pressure level, over the frequency spectrum, for which a listener perceives a constant loudness when presented with pure steady tones. [1] The unit of measurement for loudness levels is the phon and is arrived at by reference to equal-loudness contours. By definition, two sine waves of differing ...
According to Stevens' definition, a loudness of 1 sone is equivalent to 40 phons (a 1 kHz tone at 40 dB SPL). [1] The phons scale aligns with dB, not with loudness, so the sone and phon scales are not proportional. Rather, the loudness in sones is, at least very nearly, a power law function of the signal intensity, with an exponent of 0.3.
Sound exposure level (SEL) is a logarithmic measure of the sound exposure of a sound relative to a reference value. Sound exposure level, denoted L E and measured in dB , is defined by [ 1 ]
[a] A more precise model known as the Inflected Exponential function, [3] indicates that loudness increases with a higher exponent at low and high levels and with a lower exponent at moderate levels. [4] The sensitivity of the human ear changes as a function of frequency, as shown in the equal-loudness graph. Each line on this graph shows the ...
The decibel originates from methods used to quantify signal loss in telegraph and telephone circuits. Until the mid-1920s, the unit for loss was miles of standard cable (MSC). 1 MSC corresponded to the loss of power over one mile (approximately 1.6 km) of standard telephone cable at a frequency of 5000 radians per second (795.8 Hz), and matched closely the smallest attenuation detectable to a ...
The level of the stimulus is automatically varied at a fixed rate. The subject is asked to press a button when the stimulus is detectable. Once the button is pressed, the level is automatically decreased by the motor-driven attenuator and increased when the button is not pushed. The threshold is thus tracked by the listeners, and calculated as ...
In telecommunication, a standard test tone is a pure tone with a standardized level generally used for level alignment of single links and of links in tandem. [1]For standardized test signal levels and frequencies, see MIL-STD-188-100 for United States Department of Defense (DOD) use, and the Code of Federal Regulations Title 47, part 68 for other Government agencies.