Search results
Results From The WOW.Com Content Network
Later that same year, the North Carolina Consumers Council petitioned for an investigation into timing chain failures and subsequent engine failures across the model lineup for vehicles using the 2.2L engine. The resulting recall affected only a small number of vehicles built in a four-month period in late 2000 and early 2001.
The GM Ecotec engine, also known by its codename L850, is a family of all-aluminium inline-four engines, displacing between 1.2 and 2.5 litres.Confusingly, the Ecotec name was also applied to both the Buick V6 Engine when used in Holden Vehicles, as well as the final DOHC derivatives of the previous GM Family II engine; the architecture was substantially re-engineered for this new Ecotec ...
Earlier production 2.8L, 3.0L, 3.2L, and 3.6L engines with the three chain design suffered from premature timing chain failures because of a faulty PCV system and extended oil change intervals. Most of the problems occurred on pre-LFX engines.
The engine was discontinued in 2003, replaced by the 2.2-liter DOHC Ecotec engine. Although it displaces 134 cu. in, the 2.2-liter OHV is still commonly referred to as the GM 122 today, and has been reputed for its simplicity, reliability, and ease of maintenance in the J-body cars and S-series trucks, and a few L-body cars.
The first version of this engine family was a normally aspirated 2.2 L (134 cu in) unit. Developed under the leadership of Chief Engineer – Engine Design and Development Willem Weertman and head of performance tuning Charles "Pete" Hagenbuch, who had worked on most of Chrysler's V-8 engines and the Chrysler Slant-6 engine, [1] it was introduced in the 1981 Dodge Aries, Dodge Omni, Plymouth ...
The timing chain rode on one pivoting chain guide resting on the ratchet tensioner and one fixed guide attached to the engine block and cylinder head. The 1991 to 1998 DOHC engine had an upper timing chain guide in between the camshaft sprockets. The timing chain was lubricated via cast-off from the top of the cylinder head and one 'squirter ...
The 2.2l S10/Sonoma had the starter located in the same position as front wheel drive cars. A rear wheel drive bellhousing is displayed at right, and the integrated front wheel drive bellhousing is displayed at the lower right (in this case, as a part of the GM 6T70 Transmission). GM 60-Degree 2.8/3.1/3.4/3.5/3.9 L V6 (also used by AMC) Buick ...
The High Value engine family from General Motors is a group of cam-in-block or overhead valve V6 engines.These engines feature cast iron blocks and aluminum heads, and use the same 60° vee bank as the 60° V6 family they are based on, but the new 99 mm (3.90 in) bore required offsetting the bores by 1.5 mm (0.059 in) away from the engine center line.