When.com Web Search

  1. Ads

    related to: farm clevis with screw pin tool harbor freight

Search results

  1. Results From The WOW.Com Content Network
  2. Clevis fastener - Wikipedia

    en.wikipedia.org/wiki/Clevis_fastener

    The clevis is a U-shaped piece that has holes at the end of the prongs to accept the clevis pin. The clevis pin is similar to a bolt, but is either partially threaded or unthreaded with a cross-hole for a split pin. A tang is a piece that is sometimes fitted in the space within the clevis and is held in place by the clevis pin.

  3. Harbor Freight Tools - Wikipedia

    en.wikipedia.org/wiki/Harbor_Freight_Tools

    Harbor Freight Tools won a declassification of the class action; that is, the court found that all the individual situations were not similar enough to be judged as a single class, and that their claims would require an individual-by-individual inquiry, so the case could not be handled on a class basis.

  4. Eric Smidt - Wikipedia

    en.wikipedia.org/wiki/Eric_Smidt

    Harbor Freight Tools for Schools awards $1.5 million to skilled trades teachers and their schools annually. [ 10 ] Marking the opening of the 500th Harbor Freight Tools store near Chicago , Smidt announced the contribution of $100,000 and the donation of tools to Chicago Public Schools to support teachers and students in skilled trades learning ...

  5. Three-point hitch - Wikipedia

    en.wikipedia.org/wiki/Three-point_hitch

    Before the 1940s, most hitching of farm implements to tractors was done simply with a drawbar, on the same principle as a modern tow hitch. The drawbar was a flat bar with holes in it, and the implements were trailers, with tongues that attached to the drawbar with a pin through a hole.

  6. Cleco (fastener) - Wikipedia

    en.wikipedia.org/wiki/Cleco_(fastener)

    Cleco (Cleko) fasteners on an aircraft wing. A cleco, also spelled generically cleko, is a temporary fastener developed by the Cleveland Pneumatic Tool Company. [1] Widely used in the manufacture and repair of aluminum-skinned aircraft, it is used to temporarily fasten sheets of material together, or to hold parts such as stiffeners, frames etc together, before they are permanently joined.

  7. List of drill and tap sizes - Wikipedia

    en.wikipedia.org/wiki/List_of_drill_and_tap_sizes

    Example (inch, coarse): For size 7 ⁄ 16 (this is the diameter of the intended screw in fraction form)-14 (this is the number of threads per inch; 14 is considered coarse), 0.437 in × 0.85 = 0.371 in. Therefore, a size 7 ⁄ 16 screw (7 ⁄ 16 ≈ 0.437) with 14 threads per inch (coarse) needs a tap drill with a diameter of about 0.371 inches.