Ad
related to: causes of piston ring failure in engine light sensor
Search results
Results From The WOW.Com Content Network
In most steam engine designs there is a short time at the end of the return stroke of the piston when all the valves are shut and it is compressing any remaining steam. Water can be introduced from the boiler or in a cold engine, steam will condense to water on the cool walls of the cylinders and can potentially hydrolock an engine.
A piston ring is a metallic split ring that is attached to the outer diameter of a piston in an internal combustion engine or steam engine. The main functions of piston rings in engines are: Sealing the combustion chamber so that there is minimal loss of gases to the crank case.
A check engine light or malfunction indicator lamp (MIL), is a tell-tale that a computerized engine-management system uses to indicate a malfunction or problem with the vehicle ranging from minor (such as a loose gas cap) to serious (worn spark plugs, engine problems or a faulty oil valve, etc.).
Other than the piston rings, “blow-by” gases can push the fuel oil past the rings and into the crankcase. [1] “Blow-by” gases are a mix of fuel oil and exhaust gases that push past the piston rings. Crankcase dilution is caused more when the lube oil is fresher. [3] Another cause of crankcase dilution is a slow or delayed injection ...
In spark-ignition internal combustion engines, knocking (also knock, detonation, spark knock, pinging or pinking) occurs when combustion of some of the air/fuel mixture in the cylinder does not result from propagation of the flame front ignited by the spark plug, but when one or more pockets of air/fuel mixture explode outside the envelope of the normal combustion front.
It's commonly known as "Detonation or Knock". Engine management systems can overcome pre ignition by the means of a knock or detonation sensor. The sensor will detect pre ignition and retard the engines timing to protect the engine from damage. Undesired engine behavior will occur such as loss of performance or power.
This prevents boundary lubrication problems, as piston ring ridge wear at TDC and bottom dead centre (BDC) does not occur. The Bristol Hercules time between overhauls (TBO) life was rated at 3,000 hours, very good for an aircraft engine, but not so for automotive engines. [8] Sleeve wear was located primarily in the upper part, inside the 'junk ...
Particles in the oil can also cause serious problems with oil pressure. After oil flows through the engine, it returns to the oil pan, and can carry along a lot of debris. The debris can cause problems with the oil pickup screen and the oil pump itself. The holes in the oil pickup screen measure about 0.04 square inches (0.26 cm 2). [6]