When.com Web Search

Search results

  1. Results From The WOW.Com Content Network
  2. Crankcase dilution - Wikipedia

    en.wikipedia.org/wiki/Crankcase_dilution

    The job of the piston compression ring is to keep the oil and the exhaust gases from entering the crankcase, but when there is too much wear it can no longer do its job. Other than the piston rings, “blow-by” gases can push the fuel oil past the rings and into the crankcase. [1] “Blow-by” gases are a mix of fuel oil and exhaust gases ...

  3. 2009–2011 Toyota vehicle recalls - Wikipedia

    en.wikipedia.org/wiki/2009–2011_Toyota_vehicle...

    The recall concerns a steering problem caused by the misalignment of the inner and outer rings of the crankshaft pulley, which could cause noise or the Check Engine light to illuminate; if this problem is not corrected, the power steering belt can fall off the pulley, which can cause a sudden loss of power assist.

  4. Deglazing (engine mechanics) - Wikipedia

    en.wikipedia.org/wiki/Deglazing_(engine_mechanics)

    First, the lubricating oil in the engine will not adhere properly to the smooth surface, and in the absence of an oil film the resulting friction is increased. Secondly, while breaking in newly installed piston rings, a minute amount of wear must occur between rings and cylinder wall in order to seat the rings properly, and ensure a gas-tight seal.

  5. Hydrolock - Wikipedia

    en.wikipedia.org/wiki/Hydrolock

    In most steam engine designs there is a short time at the end of the return stroke of the piston when all the valves are shut and it is compressing any remaining steam. Water can be introduced from the boiler or in a cold engine, steam will condense to water on the cool walls of the cylinders and can potentially hydrolock an engine.

  6. Break-in (mechanical run-in) - Wikipedia

    en.wikipedia.org/wiki/Break-in_(mechanical_run-in)

    The break-in period required has changed over the years with improved piston ring materials and designs. In reference to small engines, the break-in period now (5–10 hours) is short in comparison with that of engines of the past. Aluminum cylinder bore engine piston rings break-in faster than those used on cast iron cylinder bores. [2]

  7. Toyota AR engine - Wikipedia

    en.wikipedia.org/wiki/Toyota_AR_engine

    The AR engine family is an Inline-4 piston engine series by Toyota, first introduced in 2008 for the RAV4, and subsequently for the Highlander, Venza, Camry and Scion tC.. The AR series uses a die-cast aluminium engine block and aluminium DOHC cylinder head.

  8. Piston ring - Wikipedia

    en.wikipedia.org/wiki/Piston_ring

    A piston ring is a metallic split ring that is attached to the outer diameter of a piston in an internal combustion engine or steam engine. The main functions of piston rings in engines are: Sealing the combustion chamber so that there is minimal loss of gases to the crank case.

  9. Toyota AZ engine - Wikipedia

    en.wikipedia.org/wiki/Toyota_AZ_engine

    The 2AZ-FE engine in the 2007-2009 Camry and 2006-2009 Rav4 may burn excessive oil and is involved in this lawsuit. [1] Other engines are also affected. [2] If this Toyota engine is burning more than 1 US quart (946 ml) of oil in 1,200 miles (1,931 km), has less than 150,000 miles (241,402 km), is less than 10 years old, and is located in the U.S., Toyota service will perform a free oil ...