Search results
Results From The WOW.Com Content Network
STP will enable this preferred link as the only path to be used for Ethernet frames between the two switches, and disable all other possible links by designating the switch ports that connect the preferred path as root port. [4]: 393 After STP enabled switches in a LAN have elected the root bridge, all non-root bridges assign one of their ports ...
Both protocols have in common various issues such as: the selection of the CIST Root Bridge (it uses the same fundamental algorithm, 17.3.1 of IEEE Std 802.1D, 2004 Edition, but with extended priority vector components within MST Regions), the selection of the MSTI Root Bridge and computation of port roles for each MSTI, the port roles used by ...
Edge STPs (signal transfer points) are networking hardware devices embedded with software that performs routing, signaling, firewall, and packet conversion functions. Their primary purpose is to unify networks that use various transports and signaling protocols – such as SS7, SIP, SIGTRAN, TDM, IP, etc. – into cohesive service environments.
IEEE 802.1aq is an amendment to the IEEE 802.1Q networking standard which adds support for Shortest Path Bridging (SPB).This technology is intended to simplify the creation and configuration of Ethernet networks while enabling multipath routing.
Get AOL Mail for FREE! Manage your email like never before with travel, photo & document views. Personalize your inbox with themes & tabs. You've Got Mail!
EtherChannel between a switch and a server. EtherChannel is a port link aggregation technology or port-channel architecture used primarily on Cisco switches.It allows grouping of several physical Ethernet links to create one logical Ethernet link for the purpose of providing fault-tolerance and high-speed links between switches, routers and servers.
A Signal Transfer Point (STP) is a node in an SS7 network that routes signaling messages based on their destination point code in the SS7 network. [1] It works as a router that relays SS7 messages between signaling end-points (SEPs) and other signaling transfer points (STPs).
The virtual router then transitions into an unsteady state and an election process is initiated to select the next primary/active router from the secondary/standby routers. This is fulfilled through the use of multicast packets. Secondary/standby router(s) are only supposed to send multicast packets during an election process.