Ads
related to: ladder stopper screwfix kit 2 speed transmission with reverse splittemu.com has been visited by 1M+ users in the past month
Search results
Results From The WOW.Com Content Network
The Powerglide is a two-speed automatic transmission designed by General Motors.It was available primarily on Chevrolet from January 1950 [1] through 1973, although some Pontiac models also used this automatic transmission after the fire at the Hydra-Matic factory in 1953.
Muncie SM319 transmission — 3-speed transmission physically identical to the Muncie SM318, with an added Borg Warner overdrive unit. Muncie SM420 transmission — 4-speed manual used up to 1967, very similar to sm 465 except small changes to gear ratios and location of reverse.
[2] This resulted in a transmission with a typical 4 speed 'H' pattern shift mechanism, plus an additional 2 speed 'high-low' selector which effectively split each of the 4 speed gears in two. This meant 8 forward gears in total. It was also possible to use the 2 speed selector in reverse, meaning that two reverse gears also existed.
A small concentric shaft inside the turbine shaft operated the front pump of the transmission to permit engagement of drive/reverse ranges when the car was stopped or moving slowly; at speeds over 15 mph (24 km/h), a differential-driven (from the car motion) rear pump of smaller capacity and greater efficiency took over and the front pump shut ...
The Ford-O-Matic two-speed transmission was introduced in 1959. A simplified version of the Cruise-O-Matic, it combined a torque connector and a compound planetary gear set. A front unit (multiple-disc) clutch provided high gear, a front band on the clutch drum provided low gear, and a band on the rear unit internal gear drum provided reverse.
A dual-clutch transmission (DCT) (sometimes referred to as a twin-clutch transmission) is a type of multi-speed vehicle transmission system, that uses two separate clutches for odd and even gear sets. [1] The design is often similar to two separate manual transmissions with their respective clutches contained within one housing, and working as ...
The 1891 Panhard et Levassor is considered a significant advance in automotive transmissions since it used a three-speed manual transmission. [2] [3] This transmission, along with many similar designs that it inspired, was a non-synchronous (also called sliding-mesh) design where gear changes involved sliding the gears along their shafts so ...
The 1941 Chrysler M4 Vacamatic transmission was a two-speed manual transmission with an integral underdrive unit, a traditional manual clutch, and a fluid coupling between the engine and the clutch. [51] [52] [53] The two-speed transmission had "high" and "low" ranges, and the clutch was used when the driver wanted to switch between ranges. For ...