Search results
Results From The WOW.Com Content Network
UDP hole punching is a method for establishing bidirectional UDP connections between Internet hosts in private networks using network address translators. The technique is not applicable in all scenarios or with all types of NATs, as NAT operating characteristics are not standardized.
Hole punching (or sometimes punch-through) is a technique in computer networking for establishing a direct connection between two parties in which one or both are behind firewalls or behind routers that use network address translation (NAT).
WireGuard is a communication protocol and free and open-source software that implements encrypted virtual private networks (VPNs). [5] It aims to be lighter and better performing than IPsec and OpenVPN , two common tunneling protocols . [ 6 ]
A punch down tool, punchdown tool, IDC tool, or a Krone tool (named after the Krone LSA-PLUS connector), is a small hand tool used by telecommunication and network technicians. It is used for inserting wire into insulation-displacement connectors on punch down blocks , patch panels , keystone modules , and surface mount boxes (also known as ...
TCP hole punching is an experimentally used NAT traversal technique for establishing a TCP connection between two peers on the Internet behind NAT devices. NAT traversal is a general term for techniques that establish and maintain TCP/IP network and/or TCP connections traversing NAT gateways.
In computer networking, a firewall pinhole is a port that is not protected by a firewall to allow a particular application to gain access to a service on a host in the network protected by the firewall.
ICMP hole punching is a technique employed in network address translator (NAT) applications for maintaining Internet Control Message Protocol (ICMP) packet streams that traverse the NAT. NAT traversal techniques are typically required for client-to-client networking applications on the Internet involving hosts connected in private networks ...
A reproducing punch might have an additional read station after the punch station for verification. Punch magnets Machines that could punch cards, such as a reproducing punch, had hub entries for each card column. An impulse to one of those entries triggered the electromagnet that initiated the punching of a hole at that column position.