Search results
Results From The WOW.Com Content Network
A compensated pulsed alternator, [1] also known by the portmanteau compulsator, is a form of power supply. As the name suggests, it is an alternator that is "compensated" (see below) to make it better at delivering pulses of electrical energy than a normal alternator.
to test series and interpoles (commutating) fields from a DC motor; to determine phasing and polarity in multiwinding armatures; to test rotors in rotating frequency changers, as well as in wound rotors; to test shorts between turns in taped coils before installation into an armature or a stator; as a low voltage isolation transformer
dynamo/alternator diode+ D- dynamo/alternator diode- DF dynamo field DF1 dynamo field 1 DF2 dynamo field 2 U, V, W AC three phase terminals Lights 54 brake lights 54g lights 54 55 fog light N 56 spot light 56a headlamp high beam and indicator light 56b low beam F 56d signal flash 57 parking lights 57a parking lights P 57L parking lights left PL 57R
The simplest type of linear alternator is the mechanically powered flashlight (shake type). This is a torch (UK) or flashlight (USA) which contains a coil and a permanent magnet. When the appliance is shaken back and forth, the magnet oscillates through the coil and induces an electric current.
If the battery becomes disconnected while it is being charged the load on the alternator suddenly decreases. However, the vehicle's voltage regulator cannot quickly cause the field current to decrease sufficiently, so the alternator continues to generate a large current. This large current causes the voltage on the vehicle bus to increase ...
The sequence of events is similar for manual or automatic synchronization. The generator is brought up to approximate synchronous speed by supplying more energy to its shaft - for example, opening the valves on a steam turbine, opening the gates on a hydraulic turbine, or increasing the fuel rack setting on a diesel engine.
Get AOL Mail for FREE! Manage your email like never before with travel, photo & document views. Personalize your inbox with themes & tabs. You've Got Mail!
The test is conducted on the high-voltage (HV) side of the transformer where the low-voltage (LV) side (or the secondary) is short-circuited. A wattmeter is connected to the primary side. An ammeter is connected in series with the primary winding. A voltmeter is optional since the applied voltage is the same as the voltmeter reading.