Ads
related to: motorcycle tire calculator size comparison
Search results
Results From The WOW.Com Content Network
A motorcycle tyre (spelt tire in American English) is the outer part of motorcycle wheel, attached to the rim, providing traction, resisting wear, absorbing surface irregularities, and allowing the motorcycle to turn via countersteering.
Bicycle and motorcycle geometry is the collection of key measurements (lengths and angles) that define a particular bike configuration. Primary among these are wheelbase , steering axis angle, fork offset, and trail.
Prior to 1964, tires were all made to a 90% aspect ratio. Tire size was specified as the tire width in inches and the diameter in inches – for example, 6.50-15. [29] From 1965 to the early 1970s, tires were made to an 80% aspect ratio. Tire size was again specified by width in inches and diameter in inches.
For example, a motorcycle with a 12 inch wide rear tire will have t = 6 inches. If the combined bike and rider center of mass is at a height of 26 inches, then a 25° lean must be increased by 7.28°: a nearly 30% increase. If the tires are only 6 inches wide, then the lean angle increase is only 3.16°, just under half.
The European Tyre and Rim Technical Organisation (ETRTO) exists to specify and harmonise sizes of rims and their associated pneumatic tyres across the European Union.ETRTO sizes apply to rims and tyres for vehicles of all types, including bicycles.
Ground pressure is the pressure exerted on the ground by the tires or tracks of a motorized vehicle, and is one measure of its potential mobility, [1] especially over soft ground. It also applies to the feet of a walking person or machine. Pressure is measured in the SI unit of pascals (Pa).
Get AOL Mail for FREE! Manage your email like never before with travel, photo & document views. Personalize your inbox with themes & tabs. You've Got Mail!
Colorized tire footprint pressure distribution. The contact patch is the portion of a vehicle's tire that is in actual contact with the road surface.It is commonly used in the discussion of pneumatic (i.e. pressurized) tires, where the term is used strictly to describe the portion of the tire's tread that touches the road surface.