Ad
related to: evolution rage 3 miter saw parts diagram for free download word
Search results
Results From The WOW.Com Content Network
A motorized miter saw. A miter saw or mitre saw is a saw used to make accurate crosscuts and miters in a workpiece by positioning a mounted blade onto a board. A miter saw in its earliest form was composed of a back saw in a miter box, but in modern implementation consists of a powered circular saw that can be positioned at a variety of angles and lowered onto a board positioned against a ...
A hand-held circular saw is the most conventional circular saw. This miter saw is a circular saw mounted to swing to crosscut wood at an angle. A table saw. Tractor-driven circular saw. A circular saw or a buzz saw, is a power-saw using a toothed or abrasive disc or blade to cut different materials using a rotary motion spinning around an arbor.
Main page; Contents; Current events; Random article; About Wikipedia; Contact us; Pages for logged out editors learn more
Attached to the saw's arbor, it is fixed relative to the blade and moves with it as blade depth is adjusted. [1] A splitter is a similar device attached to a trunion on the far side of the saw and fixed in relation to the saw table, which must be removed to make any non-through cuts or dados within the depth of the wood. [1]
Radial Arm Saw. A radial arm saw is a cutting machine consisting of a circular saw mounted on a sliding horizontal arm. Invented by Raymond DeWalt in 1922, the radial arm saw was the primary tool used for cutting long pieces of stock to length until the introduction of the power miter saw in the 1970s.
Although the coping saw is often used for similar work, the fretsaw is capable of much tighter radii and more delicate work. It has a distinctive appearance due to the depth of its frame (typically between 10 and 20 inches (25 and 51 cm)), which together with the relatively short five-inch (13 cm) blade makes this tool appear somewhat out of proportion compared with most other saws.
The earliest mitre clamps are a simple spring in a C-shape with sharpened points that are sprung onto the outside corner of the mitre joint. [citation needed]In a later design, right angled plates are higher than the screws and the holder.
A try square is made of two key parts, the blade (also known as a beam or tongue) and the stock, which are fixed together at 90° to form an 'L' shape. [4]The blade is usually made of wood or steel and is fixed into the stock, which is usually thicker than the blade and made of wood, metal or plastic.