Search results
Results From The WOW.Com Content Network
The output stops if a handset is taken off the hook. In terminology devised by phone phreaks, a ringing generator is a magenta box. The device can be used to simulate an incoming call by applying the AC ringing signal voltage to a POTS line to make the telephones on that line ring.
On hook telephone handset. The term on-hook has the following meanings: The condition that exists when a telephone or other user instrument is not in use, i.e., when idle waiting for a call. Note: on-hook originally referred to the storage of an idle telephone receiver, i.e., separate earpiece, on a switchhook.
While the sound produced is still called a "ring", [2] some phones electronically produce a warbling, chirping, or other sound. Variation of the ring signal can be used to indicate characteristics of incoming calls. For example, ringing bursts with a shorter interval between them might be used to signal a call from a given number.
When the call routing is successful and the receiving telephone is not already in a call, the destination telephone receives an electrical signal, called power ringing, or the ring tone, to alert the recipient of the incoming call. During this period of alerting, the caller also receives a distinctive signal, audible ringing, also called ...
The Answer 1571 service, a cut-down version of BT Group's Call Minder service, allows a calling party to leave messages when the called party is engaged or does not answer within a fixed number of rings. The system allows for the storage of up to 20 messages, each of which can be up to 2 minutes long, for up to 60 days (or 20 days once they ...
Some telephone technicians used mnemonic phrases, such as red-right-ring-rear, or ring-right-red-rough, to remember that the red wire connects to the right-side post in the wall jack and to the ring on the plug and to the rear lug on main distribution frames. Sometimes rough or ridge was added for jumper wires with a tactile code. [citation needed]
In the early days of telephony, with operator handling calls, the addressing formation is by voice as "Operator, connect me to Mr. Smith please". In the first half of the 20th century, addressing formation is done by using a rotary dial , which rapidly breaks the line current into pulses , with the number of pulses conveying the address.
A lineman's handset typically connects via a pair of test leads, not the modular connector found on most consumer telephone equipment. The test leads will feature some combination of alligator clips (to connect to bare wires), a piercing spike or "bed-of-nails" (for insulated wires), and something designed to fit a punch block.