Search results
Results From The WOW.Com Content Network
When Secure Boot is enabled, it is initially placed in "setup" mode, which allows a public key known as the "platform key" (PK) to be written to the firmware. Once the key is written, Secure Boot enters "User" mode, where only UEFI drivers and OS boot loaders signed with the platform key can be loaded by the firmware.
The boot loader on the option ROM would attempt to boot from a disk, network, or other boot program source attached to or installed on the adapter card; if that boot attempt failed, it would pass control to the previous boot loader (to which INT 19h pointed before the option ROM hooked it), allowing the system to boot from another device as a ...
In Windows, the user can use the tool like ATATool to create a DCO. The user can set DCO to 100GB on hard drive 1: ATATOOL /SETDCO:100GB \\.\PhysicalDrive1 The user can remove DCO of 100GB on hard drive 1: ATATOOL /RESTOREDCO:100GB \\.\PhysicalDrive1 These commands can cause data loss or worse if they exeute this command that contains data. [6]
Convert Windows Vista SP1+ or 7 x86_64 boot from BIOS-MBR mode to UEFI-GPT mode without Reinstall; Support for GPT (Partition scheme) and HDD greater than 2.19 TB in Microsoft Windows XP; Setting up a RAID volume in Linux with >2TB disks
When a system on a chip (SoC) enters suspend to RAM mode, in many cases, the processor is completely off while the RAM is put in self refresh mode. At resume, the boot ROM is executed again and many boot ROMs are able to detect that the SoC was in suspend to RAM and can resume by jumping directly to the kernel which then takes care of powering on again the peripherals which were off and ...
On Apple Mac computers using Intel x86-64 processor architecture, the EFI system partition is initially left blank and unused for booting into macOS. [13] [14]However, the EFI system partition is used as a staging area for firmware updates [15] and for the Microsoft Windows bootloader for Mac computers configured to boot into a Windows partition using Boot Camp.
UEFITool is a software program for reading and modifying EEPROM images with UEFI firmware. [1] It is written in C++ using the Qt library. [2] Features include the ability to view the flash regions and to extract and import them. [3] UEFITool allows the user to search for hex and text patterns. [4] UEFITool presents UEFI firmware images in a ...
coreboot, formerly known as LinuxBIOS, [5] is a software project aimed at replacing proprietary firmware (BIOS or UEFI) found in most computers with a lightweight firmware designed to perform only the minimum number of tasks necessary to load and run a modern 32-bit or 64-bit operating system.