When.com Web Search

  1. Ads

    related to: installing amp power running boards

Search results

  1. Results From The WOW.Com Content Network
  2. Realistic Controls - Wikipedia

    en.wikipedia.org/wiki/Realistic_Controls

    Its motherboard had a Z80 processor running at 4 MHz, an 8257/8275 memory mapped video controller address at 0×F800, and an 8251 serial controller for input/output. There were six S-100 bus interfaces, one of which was occupied with a 5.25-inch disc controller card.

  3. Mesa/Boogie Mark Series - Wikipedia

    en.wikipedia.org/wiki/Mesa/Boogie_Mark_Series

    In a simul-class amp, running all four tubes generates approximately 75 watts RMS of power; running only the class A tubes produces about 15 watts. Also available were non-simul-class Mark IIBs in both a 60 watt version and a 100 watt version that allowed shifting down to 60 watts by turning off a pair of power tubes.

  4. Peavey Electronics - Wikipedia

    en.wikipedia.org/wiki/Peavey_Electronics

    Circuit board layout is conservative, easy to access, repair or modify. Dynamics and reliability are excellent. Its only weak point is that the preamp and power amp modules are installed in the chipboard cabinet with lack of electromagnetic shielding, resulting in a need to physically separate the amp head from bass pickups and speakers.

  5. Guitar amplifier - Wikipedia

    en.wikipedia.org/wiki/Guitar_amplifier

    Mesa-Boogie Mark IV, a guitar combo amplifier. A guitar amplifier (or amp) is an electronic device or system that strengthens the electrical signal from a pickup on an electric guitar, bass guitar, or acoustic guitar so that it can produce sound through one or more loudspeakers, which are typically housed in a wooden cabinet.

  6. Anderson Powerpole - Wikipedia

    en.wikipedia.org/wiki/Anderson_Powerpole

    This is an accepted version of this page This is the latest accepted revision, reviewed on 4 October 2024. Family of electrical connectors Anderson Powerpole Anderson Powerpole 15/30/45 ampere housings and contacts (front view) Type Electrical connector The Anderson Powerpole is a family of electrical connectors by Anderson Power Products (APP), although plug compatible connectors are now ...

  7. Bridged and paralleled amplifiers - Wikipedia

    en.wikipedia.org/wiki/Bridged_and_paralleled...

    For a given output voltage swing, the lower the impedance the higher the amplifier load. Bridging is used to allow an amplifier to drive low loads into higher power, because power is inversely proportional to impedance and proportional to the square of voltage, according to the equation = /. This equation also shows that bridging quadruples the ...