Search results
Results From The WOW.Com Content Network
A spiral pump, sometimes called a Wirz pump or incorrectly Wirtz pump, is a low lift pump which is composed of a long piece of metal plating, which is wound into a coil and sealed at the top and back extremities so as to resemble a cylinder. The outer cavity serves as the inlet, while the inner (partial) tube serves as the outlet.
A chain pump is a type of water pump that uses a chain to move water from one place to another. It works on the principle of a continuous loop of chain moving through a series of sprockets, with attached buckets that lift water as the chain passes over the top sprocket and discharge it as the chain reaches the bottom. [12]
The traditional hot water recirculation system uses the existing cold water line as return line from the point of use located farthest from the hot water tank back to the hot water tank. The first of two system types has a pump mounted at the hot water heater while a "normally open" thermostatic control valve gets installed at the farthest ...
Butch, femme, drag, camp, zhuzh and more are now in common parlance, thanks to Polari, as well as some quite spicy terms, like cherry, dish and more (but more on that later).
Different types of pumps are suitable for different applications, for example: a pump's maximum lift height also determines the applications it can be used for. Low-lift pumps are only suitable for the pumping of surface water (e.g., irrigation, drainage of lands, ...), while high-lift pumps allow deep water pumping (e.g., potable water pumping ...
A 0.75 HP bore-well submersible pump which had been used to pump groundwater One style of submersible pump for industrial use. Outlet pipe and electrical cable not connected. A submersible pump (or electric submersible pump (ESP) is a device which has a hermetically sealed motor close-coupled to the pump body. The whole assembly is submerged in ...
The PlayPump water system is a playground merry-go-round attached to a water pump. The spinning motion pumps underground water into a 2,500-liter tank raised seven meters above ground. The water in the tank is easily dispensed by a tap valve. According to the manufacturer the pump can raise up to 1400 liters of water per hour from a depth of 40 ...
This is the principle behind a positive displacement pump, for example the manual water pump. Inside the pump, a mechanism expands a small sealed cavity to reduce its pressure below that of the atmosphere. Because of the pressure differential, some fluid from the chamber (or the well, in our example) is pushed into the pump's small cavity.