Ads
related to: tram 1499 cb base antenna
Search results
Results From The WOW.Com Content Network
The antenna may not be more than 20 feet (6.1 m) above the highest point of the structure it is mounted to, or the highest point of the antenna must not be more than 60 feet (18.3 m) above the ground (47 CFR 95.408(c)) if installed in a fixed location. [4] CB radios must include AM or SSB modulation and may include frequency modulation. [5]
After the 1973 oil crisis, the U.S. government imposed a nationwide 55 mph speed limit, and fuel shortages and rationing were widespread.Drivers (especially commercial truckers) used CB radios to locate service stations with better supplies of fuel, to notify other drivers of speed traps, and to organize blockades and convoys in a 1974 strike protesting the new speed limit and other trucking ...
Although no real antenna can be exactly isotropic, a few antennas are built to be as near to isotropic as possible; they are used for emergency backup antennas and for test equipment for other antennas: Because the received and transmitted signal strength is the same in (almost) every direction, they work without any need for them to be any ...
The base station is one end of a communications link. The other end is a movable vehicle-mounted radio or walkie-talkie. [6] Examples of base station uses in two-way radio include the dispatch of tow trucks and taxicabs. Basic base station elements used in a remote-controlled installation. Selective calling options such as CTCSS are optional.
Land mobile radio systems are widely used by the military. Separate bands in the radio spectrum are reserved for their use. This includes portions of the 30-50 MHz band, and the entire 100-100, 100-100.8, and 540-2400 MHz bands, plus shared use of the 170- 170 MHz band.
Collinear dipole array on repeater for radio station JOHG-FM on Mt. Shibisan, Kagoshima, Japan. In telecommunications, a collinear antenna array (sometimes spelled colinear antenna array) is an array of dipole or quarter-wave antennas mounted in such a manner that the corresponding elements of each antenna are parallel and collinear; that is, they are located along a common axis.