Search results
Results From The WOW.Com Content Network
The first and historically most important application for communication satellites was in intercontinental long distance telephony. The fixed Public Switched Telephone Network relays telephone calls from land line telephones to an earth station, where they are then transmitted a receiving satellite dish via a geostationary satellite in Earth orbit.
Network terminal nodes are at the edges of the network. In the context of telecommunications, a terminal is a device which ends a telecommunications link and is the point at which a signal enters or leaves a network. Examples of terminal equipment include telephones, fax machines, computer terminals, printers and workstations.
A split-50 M-type 66 block with bridging clips attached. A 66 block is a type of punch-down block used to connect sets of wires in a telephone system. They have been manufactured in four common configurations, A, B, E and M. [a] A and B styles have the clip rows on 0.25" centers while E and M have the clip rows on 0.20" centers. The A blocks ...
A telecommunications network is a group of nodes interconnected by telecommunications links that are used to exchange messages between the nodes. The links may use a variety of technologies based on the methodologies of circuit switching, message switching, or packet switching, to pass messages and signals.
The protocols in use today in this layer for the Internet all originated in the development of TCP/IP. In the OSI model the transport layer is often referred to as Layer 4, or L4, [2] while numbered layers are not used in TCP/IP. The best-known transport protocol of the Internet protocol suite is the Transmission Control Protocol (TCP).
In telecommunications, the term terminal equipment has the following meanings: Communications equipment at either end of a communications link , used to permit the stations involved to accomplish the mission for which the link was established.
Typical delays for modern communication transmission lines vary from 3.33 ns/m to 5 ns/m. When sending power down a transmission line, it is usually desirable that as much power as possible will be absorbed by the load and as little as possible will be reflected back to the source.
IBM Turboways ATM 155 PCI network interface card. Asynchronous Transfer Mode (ATM) is a telecommunications standard defined by the American National Standards Institute and International Telecommunication Union Telecommunication Standardization Sector (ITU-T, formerly CCITT) for digital transmission of multiple types of traffic.