Search results
Results From The WOW.Com Content Network
Communication is very important in ports because ports are areas with high risks; by good communication, people can avoid risks. In the design process, people should consider adding more base stations to ensure good quality of radio contact and video contact.
In telecommunications, Multiprotocol Label Switching - Transport Profile (MPLS-TP) is a variant of the MPLS protocol that is used in packet switched data networks. MPLS-TP is the product of a joint Internet Engineering Task Force (IETF) / International Telecommunication Union Telecommunication Standardization Sector (ITU-T) effort to include an MPLS Transport Profile within the IETF MPLS and ...
Terminal symbol A terminal strip, to which wires can be soldered. A terminal is the point at which a conductor from a component, device or network comes to an end. [1] Terminal may also refer to an electrical connector at this endpoint, acting as the reusable interface to a conductor and creating a point where external circuits can be connected.
IBM Turboways ATM 155 PCI network interface card. Asynchronous Transfer Mode (ATM) is a telecommunications standard defined by the American National Standards Institute and International Telecommunication Union Telecommunication Standardization Sector (ITU-T, formerly CCITT) for digital transmission of multiple types of traffic.
Network terminal nodes are at the edges of the network. In the context of telecommunications, a terminal is a device which ends a telecommunications link and is the point at which a signal enters or leaves a network. Examples of terminal equipment include telephones, fax machines, computer terminals, printers and workstations.
Transport of network management data between the network management system terminal and the SONET/SDH equipment, e.g. using TL1/Q3 protocols. Transport of network management data between SDH/SONET equipment using dedicated embedded data communication channels (DCCs) within the section and line overhead.
Typical delays for modern communication transmission lines vary from 3.33 ns/m to 5 ns/m. When sending power down a transmission line, it is usually desirable that as much power as possible will be absorbed by the load and as little as possible will be reflected back to the source.
This page was last edited on 14 March 2024, at 21:48 (UTC).; Text is available under the Creative Commons Attribution-ShareAlike 4.0 License; additional terms may ...