Search results
Results From The WOW.Com Content Network
[1] [2] [3] Induction furnace capacities range from less than one kilogram to one hundred tons, and are used to melt iron and steel, copper, aluminum, and precious metals. The advantage of the induction furnace is a clean, energy-efficient and well-controlled melting process, compared to most other means of metal melting.
The Inca bronze alloys were also of this type. Arsenic is often an impurity in copper ores, so the discovery could have been made by accident. Eventually, arsenic-bearing minerals were intentionally added during smelting. [citation needed] Copper–tin bronzes, harder and more durable, were developed around 3500 BC, also in Asia Minor. [15]
For example, Paraffin has very large molecules and thus a high heat capacity per mole, but as a substance it does not have remarkable heat capacity in terms of volume, mass, or atom-mol (which is just 1.41 R per mole of atoms, or less than half of most solids, in terms of heat capacity per atom).
The thermites are characterized by almost complete absence of gas production during burning, high reaction temperature, and production of molten slag. The fuel should have high heat of combustion and produce oxides with low melting point and high boiling point. The oxidizer should contain at least 25% oxygen, have high density, low heat of ...
While the INCO flash furnace at Sudbury was the first commercial use of oxygen flash smelting, [6] fewer smelters use the INCO flash furnace than the Outokumpu flash furnace. [4] Flash smelting with oxygen-enriched air (the 'reaction gas') makes use of the energy contained in the concentrate to supply most of the energy required by the furnaces.
Ideally, the melt rate stays constant throughout the process cycle, but monitoring and control of the vacuum arc remelting process is not simple. [5] This is because there is a complex heat transfer occurring involving conduction, radiation, convection within the liquid metal, and advection caused by the Lorentz force .
The theoretical minimum amount of energy required to melt a tonne of scrap steel is 300 kWh (1.09 GJ) (melting point 1,520 °C (2,768 °F)). Therefore, a 300-tonne, 300 MVA EAF will require approximately 132 MWh of energy to melt the steel, and a "power-on time" (the time that steel is being melted with an arc) of approximately 37 minutes.
Melting ice cubes illustrate the process of fusion. Melting, or fusion, is a physical process that results in the phase transition of a substance from a solid to a liquid. This occurs when the internal energy of the solid increases, typically by the application of heat or pressure, which increases the substance's temperature to the melting point.