Search results
Results From The WOW.Com Content Network
Dynamic Amplification Factor (DAF) or Dynamic Increase Factor (DIF), is a dimensionless number which describes how many times the deflections or stresses should be multiplied to the deflections or stresses caused by the static loads when a dynamic load is applied on to a structure.
The specimen showing stable crack growth shows an increasing trend in fracture toughness as the crack length increases (ductile crack extension). This plot of fracture toughness vs crack length is called the resistance (R)-curve. ASTM E561 outlines a procedure for determining toughness vs crack growth curves in materials. [18]
Dynamic pressure is one of the terms of Bernoulli's equation, which can be derived from the conservation of energy for a fluid in motion. [1] At a stagnation point the dynamic pressure is equal to the difference between the stagnation pressure and the static pressure, so the dynamic pressure in a flow field can be measured at a stagnation point ...
Plant growth analysis refers to a set of concepts and equations by which changes in size of plants over time can be summarised and dissected in component variables. It is often applied in the analysis of growth of individual plants, but can also be used in a situation where crop growth is followed over time.
Theoretically, it is easy to calculate ecological efficiency using the mathematical relationships above. It is often difficult, however, to obtain accurate measurements of the values involved in the calculation. Assessing ingestion, for example, requires knowledge of the gross amount of food consumed in an ecosystem as well as its caloric ...
The dynamic structure factor is most often denoted (,), where (sometimes ) is a wave vector (or wave number for isotropic materials), and a frequency (sometimes stated as energy, ). It is defined as: [ 1 ]
In econometrics, a dynamic factor (also known as a diffusion index) is a series which measures the co-movement of many time series. It is used in certain macroeconomic models. A diffusion index is intended to indicate the changes of the fraction of economic data time series which increase or decrease over the selected time interval,
Given these assumptions, the flux of oxidant through each of the three phases can be expressed in terms of concentrations, material properties, and temperature. = = = where: is the gas-phase transport coefficient, is the concentration of oxidant in the surrounding atmosphere, is the concentration of oxidant in the surface of the oxide, is the concentration of the oxidant at the interface ...